0
Oldsmobile Ciera
Manufactured by General Motors from 1982 to 1996, the Ciera was a mid-size car and the best-selling model of Oldsmobile. It was offered in 2-door sedan, 4-door coupe and 4-door station wagon body styles.
697 Questions
How do you fix code P0480 on Oldsmobile cutlass?
That is cooling fan 1 control circuit malfunction. check out the fan motor, and temperature sending unit, fan relay, and fuse.
Where is the throttle positioning sensor on a 1989 Oldsmobile with a 2.8 Liter 6 cylinder engine?
The throttle positioning sensor is located in the throttle body.
Does a 92 and a 94 cutlass ciera use the same oil?
Probably. Generally it's either 5w30 or 10w30. If they have the same engine, even more likely.
How do you install crankshaft sensor on 92 Oldsmobile cutlass ciera 3.3?
remove serpentine belt, turn crank with ratchet to align an open space on sensor which is behind harmonic balancer, disconnect plug on sensor, remove the 2, 13mm bolts and slip it out. put new one in by looking straight down behind harmonic balancer and see that the bands slip through the magnetic sensors without touching, tighten small 8mm screw which sets it in place, around 30 lbs. torque.
Something is mis-aligned. Check the mounting brackets to see if anything is bent. Make sure that the alternator and any other accessories are aligned properly and that all of the bolts are used to keep the accessories from twisting out of alignment. If the mounting bracket is bent you may need to get a replacment.
Where is the flasher relay located on a 1996 Oldsmobile Cutlass Ciera?
esta localizado a lado del pasajero no mas quitas la bosina y talvez puedas quitarlo si no quita la guanter buena suerte es un cubito como de 2 pulgadas de redondo y de largo como 2 tambien si trae el original el nuevo va hacer un poco mas grande
How do you stop your 95 cutlass ciera from clunking when you put it in reverse?
Sounds like a transmission problem
How do you fix a 97 Buick speedometer and odometer that does not always function?
if trans shift is affected, then losing signal to PCM from trans if not affected then losing signal to dash or dash itself is problem use scanner to see if VSS is showing speed when dash does not
How many gallons of gas does a 1993 4 door cutlass ciera hold?
Your tank should be a 16 gallon tank. That is what mine is, I have a 1993 also.
Where is the starter located on a 1996 Oldsmobile Ciera?
The starter is in front of the engine, fairly centered, and easiest to get to from underneath the car. It and the solenoid are a pair of cylinders with wires hooked to them.
What kind of hardware is needed to replace catalytic converter?
depens on what car u have but i hav always had to use two 13mm renchs
Where is the ecm on a 1996 olds ciera?
It is located directly on the firewall behind the glove box. It is easier to remove with less chance of damaging the ecm holder if you remove the screws on the front of the glove box, the screw holding the glove box retaining cable, and the bottom screws holding up the bottom cover just below the glove box. This will be easy since all of the screws are 7mm screws. The screws that hold the pins onto the ecm are also 7mm. You will then remove the ecm from the bottom but by taking the glove box out you can actually see what you are doing.
Where is the orifice tube located on a 1995 Oldsmobile Cutlass ciera?
its located on the lower left side of the condenser ,, drivers side. its in the tube with the brass connecter nut ,... if you seperate the connector you can look up into the top tube and pull it out with needle nose pliers.... yes
How do you replace the speed sensor on a 89 Olds Cutlass Ciera?
Raise the vehicle and locate the speed sensor. Remove the electrical plug. Turn the speed sensor counterclockwise and remove it. Install the new speed sensor.
How do you fix a heavy idle on a 1986 Oldsmobile cutlass Ciera?
a lose accelorater cable may be to blame. or a bad air filter, bad oil, poor vaccumm, low compresion
/
Car just had manifold intake gasket work done, it idles very high in neutral and park, Drive is good, but wants to jump out of the gate. Any suggestions?
Where is the rear defogger relay located in your Hyundai Accent GL 2000 4 Door?
The rear defogger relay is locate under the dashboard. Remove the screws holding the cover panel around the steering wheel and pull it off.
Left of the steering column you will see the relay (usually black) held on with one 10mm bolt.
Where is the oil filter on a1993 olds cutlas ciera?
if you look on left side underneath the engine behind a metal panel, you must take panel off to get to the oil filter
Where do you find the location of a cooling fan relay on a 1993 Oldsmobile Cutlass Ceria?
cooling fan relays very seldom go out, I would check the cigarette lighter, first and make sure it is not shorting out .people spend lots of money buying water pumps, radiators etc, when it is not needed on these cars the fans run on the same circut as the lighter, just got through buying a 1994 cutless for $50 because it was heating up and they thought it was the block afer they replaced all water componets, I pulled it home got a screw driver and pulled a penny that was stuck in the lighter sockett, returned the penny to the owner now I am happy motoring
How do you remove crankshaft bracket from 1990 olds ciera?
Take the crankshaft bolt off,big bolt holding the crankshaft to the engine,can be a little difficult pull the crankshaft out and the bolts should be right there,go in through the wheel well,youll have to remove your passenger tire first
How do you remove the water pump on a 1994 Oldsmobile Cutlass Sierra?
How do you replace the turn signal flasher on a 1993 Cutlass Ciera?
I just replaced mine, it was flashing erratically. It's located behind the fuse block which is in the glove compartment. Instead of removing the fuse block though I found it much easier to remove the ash try (4 screws), and to the right of that inside the dash was the flasher unit hanging right there.
Where is the thermal flasher in a 91 olds ciera?
To find the turn signal flasher remove the ash tray and it's mounting bracket. It's located just above the ash tray and below the stereo. The 4 way flasher requires removing the glove box and is located on the back right side behind the glove box.
