How do you replace the front brake pads on your 1986 Oldsmobile Cutlass Cierra?
Pretty good summary on the Autozone site - http://www.autozone.com/az/cds/en_us/0900823d/80/0f/47/f7/0900823d800f47f7/repairInfoPages.htm Briefly, 1. Jack up the car - remove the front wheel 2. From the back side of the caliper, remove the two allen-head bolts that hold the caliper on. 3. Compress the piston enough to give slack enough to lift the caliper off the disk. 4. Remove the old pads from the caliper 5. Use a large C clamp to compress the caliper piston fully 6. Insert the new pads in the caliper 7. Place the caliper back in position on the disk 8. Fasten the caliper down with the two allen-head bolts 9. Reinstall the wheel 10. Repeat on the other side. 11. Pump the brakes a few times at the beginning of your test drive
Where is the turn signal flasher located on a 1995 Oldsmobile Cutlass?
everyone should have a manual for their vechicle, and the library should have a professional shop manual available in the reference section for FREE to make copies of--the PRO manual has more detailed info, and may have wiring diagrams when needed...read up and fix 'em like a PRO...good luck Dave :)
How do you replace starter on olds 92 cutlass ciera?
Disconnect the - battery cable
Raise and support vehicle
Disconnect wiring at top of starter
Remove starter mounting bolts
Remove starter
I believe it is a draining bolt, and easier way to drain or flush the coolant from the cooling system.
1991 olds ciera 3.3 OBD code 42?
Code 42 is : Electronic Spark Timing Curcuit (EST), Direct Ignition System (DIS) fault- bypass curcuit open or shorted to ground or, Fuel cutoff relay curcuit open- or shorted to ground. I have the exact sam problem so If you find anything please post it. Thanks
Where is the inertia switch located on a 1989 Oldsmobile Cutlass Ciera?
I don't believe that GM used inertia switchs on their cars. That's Ford. GM uses a simpler, and better system. If there is no oil pressure, the fuel system wont turn on.
How do you fix a driver side window that is off track on a 1996 Oldsmobile Ciera?
how replace vertical window guide channel
How to replace idler pulley on 1992 Olds Cutlass Ciera?
take off the belt and there is one bolt take it off and put a new one one.
I was told by R-Axles in Gainsville, Florida, that replacement half shafts are being plagued with problems, because of poor foreign replacements. They look great in the box, but fail, possibly like yours. I have to say, not only did R-Axles send me back an OE shaft, but inside the box was rubber gloves, papertowels and a pocket knife as a gift for the order. And extremely nice on the phone. Give em a call. CF
Where is the horn relay on a 1994 Oldsmobile cutlass Ciera?
the horn relay switch is in the fuse panel or it should be on the horn wires itself
Where is the starter located in a 1993 Oldsmobile Cutlas Sierra?
When you look from under the hood, it will be to the right of the Engine Oil Filter.
How many quarts of oil are needed on the 2.5 L engine of an 1988 Oldsmobile Cutlass Ciera?
4.5 Quarts. With oil filter, 4.0 quarts without.
Where is the fuel filter for a 1996 Oldsmobile ciera 6-cylinder?
drivers side on the frame rail above the rear axle
Where is the camshaft sensor on a 1989 olds ciera 2.8L?
There isn't one on that engine. Only a crankshaft sensor at the back of the engine.
How do you replace a starter on a 85 cutlass?
The starter on a 85 Cutlass is replaced by disconnecting the battery, unbolting the starter, disconnecting the wires at the starter, and removing it from the vehicle. The new starter is then wired up and bolted to the engine block.
Where is the oil pressure sending unit located on a 1989 Cutlass Ciera with 3.3 L V6?
On the 2.8 its on the oil filters right, it will have a little wire comming from it. If it has blown, it may be hard to find as it will be buried in sludge. Again that's on the 2.8. Cant say that's where it is on the 3.3.
The TCC(Torque Converter Clutch) solenoid needs a replacement. Chevy Cavalier is also the Cadillac Cimarron. Replacement costs anywhere from $150 to as much as $500 if you can find the right mechanic with the right price. I got mine done for $150 in Chicago. GM dealer told me $600
How do you tighten a serpentine belt on a 1996 Oldsmobile ciera?
How do you tighten the serpentine belt on an oldsmobile ciera
Where is the oil pressure switch located on a 1995 Oldsmobile Ciera?
Under hood, center, front engine area, below valve cover, mounted in engine block.
How much does a paint job cost?
Well it depends what can of paint job you want and then you will find out =).
Is it possible for the battery in a car to freeze in cold weather?
no, its not possible. Actually it is possible for the battery to freeze, if the charge gets low enough it will freeze.
Most high pressure lines have a red cap on them, and they are usually smaller in diameter. It runs from the condenser to the TX valve/Evaporator.
What is the fuse diagram for a 1995 Oldsmobile cutlass cierra?
The fuse diagram tells you what each fuse is for (what circuit the fuseprotects) , the number on the fuse tells you how many amps the fuse can handle before it will blow.
1993 Oldsmobile cutlas cierra checking charging system for alternator?
You need a voltmeter. A fully charged battery is 12.6 volts. With the engine running the voltage on the battery supplied by the alternator should be 13 to 14 volts. A few auto parts stores will do the check for you if the battery has enough charge to get you there.