0
Oldsmobile Ciera
Manufactured by General Motors from 1982 to 1996, the Ciera was a mid-size car and the best-selling model of Oldsmobile. It was offered in 2-door sedan, 4-door coupe and 4-door station wagon body styles.
697 Questions
What oil filter does a 1996 Oldsmobile Ciera take?
ACDelco PF-47.
Purolator Classic L10111.
Fram Extra Guard PH3387A
Where would the solenoid switch be located on a 1994 Oldsmobile ciera?
The solinoid is located on the top of the starter. Generally the starter is located on the front of the car, or the left side of the engine, next to the transmission.
What would make a 1988 Olds Cutlass Ciera hard to start?
prob a bad battery if it doesn't get enough charge from altenater to resupply cold cranking amps iniatal cranking will be hard so get your altenater and battery checked Sometimes it can be the oil. Some people don
How do you remove the blower motor and fan on a 1990 Cutlass Ciera?
The radiator fan motor is conected to the shroud by 4 -10 mm screws. remove them and lower fan motor bracket down to allow access to the electrical connection from the motor it is a press fit with a latch. With electrical disconnected lift up and out of the engine compartment. After it is out there are three screws holding motor to bracket. The fan blade is attached by one nut -left hand thread.
Show pictures off 91 cutlass ciera?
If you wanted to see pictures of cars that people change stuff then go to Cardomain.com, For basic pictures the just use Google images.
How do you remove dome light on 85 cutlass cierra?
You should be able to pull the lens off to get to the bulb. After you take the bulb out you will see 2 little round pins. Just pull them of and disconnect the wires.
Where is the relay switch on a 1993 Cutlass Ciera S Oldsmobile four door?
The Relay for what - door locks or something else?
Where is the fuel pump in a 1987 Cutlas Ciera?
It is probably IN the gas tank. You will have to drop the gas tank to get to it.
How do you replace the PS pulley on a 95 ciera sl?
First remove the entire PS pump, then remove the pulley with a puller tool. This tool is available at many auto parts stores and can sometimes be rented. I found one at Canadian Tire. The pump shaft seal should be replaced at this time as it is usually a source of leaks if it has not been replaced before on this age of car. To remove it, carefully drill 2 small holes in the metal seal frame about 180 degrees opposite to each other, and put in a screw about 1/4 inch longer than the amount of exposed pump shaft and the seal will come out by prying under the screw heads. Clean all old oil out of the seal area, and then install a new seal by carefully tapping it in place using a deep socket with slightly larger diameter than the seal. Now, a pulley installation tool for GM vehicles is required to press the pulley onto the pump shaft. The tool is threaded into the shaft center, and then the upper part is turned which forces the pulley onto the shaft. This job may be somewhat of a challenge for beginners so it's probably best done by those with some mechanical aptitude and experience, but it's generally not considered to be a difficult job.
How do you remove the rear trunk lock on a 93 Cutless Ciera S?
Undo the rivet under the lock, pop the black clip out and the lock slides out.
Where is the speed sensor located on a 1996 Oldsmobile cutlass ciera?
It should Be located on the top of the transmission.
How do you install a throttle position sensor on a 1993 Oldsmobile ciera with a 3.3L V6?
The throttle position sensor (TPS) on the 1993 General Motors/Oldsmobile Ciera with the 3.3L V6 is located as part of the throttle body assembly. The removal and reinstall of the TPS is simple between disconnecting and cleaning the wiring harness, and removing the two restraining screws on the bad unit. The OEM AC Delco TPS for this application is part #213915.
How do you remove hubcaps for 1989 Oldsmobile Cutlas Sierra?
Try using the lug wrench. If the car has wire wheel caps, you will need an adapter tool to pry off the center caps and unscrew the cap from the wheel
Where is the throttle body on a 1996 Oldsmobile cutlass ciera?
Beneath The Air Filter, Or Duct Work From The Air Filter. If You Have A V6 In The Center On Top Of The Engine. Its Looks Kinda Like A Carburator. Good Luck
Where is the fuel pump located on a 1991 Oldsmobile Cutlass Ciera?
In the tank, the following is a run down of how to replace it..
This is actually a pretty involved repair. You have to have the car jacked up on all 4 corners, or up on a car lift. Disconnected battery, and it is recommended you have as much gas as possible drained from the tank. Then underneath the car you will find the tank with 2 staps holding it in place. Those staps should be taken off or at least out of the way while the tank is being supported. There are vacume lines, the fuel fill and vent lines, and the wiring harness that all have to be unhooked. Once you are sure that all lines are disconnected, drop the tank and pull to the side. Wash the top of the tank off, there will be dirt and rocks on top of it, and you need to get all of these out of the way. You will see where the wiring harness goes into the fuel sending unit. Around that peice is a slide ring that has to be gently hammered counter clockwise. Once it is free from its retaining clips, the fuel sending unit will have to be wiggled out very carefully. Once out, you will see the fuel pump mounted in line on the fuel sending unit. You will have to work out how its mounted in line, and get it off and unplugged. Reinstall the new fuel pump and reverse the procedure.
Parts needed:
Fuel Strainer
Fuel pump
Lock ring O-ring
Posibly the fuel sending unit if you were having problems with your gas gauge.
How do you open back trunk no key trunk release cable broken?
To open a trunk when there is no key and the cable release is broken, it is necessary to remove the back part of the rear seat. In some vehicles there is a small part of the bench seat back that will pull down to access the trunk.
How do you replace headlamps in '96 Oldsmobile Ciera?
To replace the headlight bulbs on a olds ciera remove the park light then remove the 4 screws that hold the composite in pull the composite light out and then you can change the bulbs it is really easy to do just remove the park light and you will see the screws
How do you replace the headlight bulb located on a 1991 Oldsmobile Ciera?
This may seem like a lot of work but its not.
The first thing you want to do is take off the side marker light in the front on the side you want to work on. They are held in with 3 screws. After that you want to take out the grill. There should be 6 screws. After that on each head light you will see 4 bolts. Take the 4 bolts out and the whole housing will come out and on the back of that you will see the light bulbs. Disconnect the wire connector for the bad one and gently twist out. To install just do the steps backwards.
Where is the fuel pump relay located on a 94 ciera?
Its behind the glove compartment,it`s placed right above the computer module. There`s three relays in there Im not sure wich one it is. You can see it if you remove the bottom cover that`s below the glove compartment. It has two screws holding it, once you drop it, youll see the computer module, an aluminum square flat box and to the side of it you`ll see the relay box with a few fuses. The relays are above those fuses. Getting the relays out its a hole different ball game. You can get the manufatures manual at an AutoZone store. My 1994 3.1L Oldsmobile, Cutlass Ciera, the Fuel Pump relay is in the engine comp, right side, with 4 other relays. The fuel pump relay has a short wire with a connector on it, that is meant to prime the fuel system. When you add power to that line, you will hear the fuel pump pressure up. That Relay has 5 posts on it.
Where is the vacuum hose for a cutlass supreme transmission?
Look under the air filter and mounted on the transmission facing the radiator is a gray and round metal valve with a vacuum line attached.
Fuel pump relay location and number 1996 Oldsmobile ciera?
I believe the 4cyl. has no relay. With the larger engines it should be located under the hood just behind passenger side headlight.
The 2.8, 3.1 and 3.4 are all the same block throughout all years. The only thing that really changed was the style of head, the intake, and a roller camshaft. It should be a direct swap for what you are wanting to do however.
Where is the turn signal flasher located on a 1985 cutlass supreme?
I had a heck of a time finding mine also. This car uses two. One mounted in the fuse box is for the emergency flashers. The other is mounted just under the dash next to the steering column....just to the right of it. There's a small bracket it snaps into.
Where is the crank sensor on 1991 olds cutlass ciera?
the crank sensor is behind the harmonic balancer
Where is the flasher unit on a 1996 Oldsmobile Ciera?
The turn signal Flasher Relay is located front seating area, driver side, under dash, passenger side of steering column, mounted behind instrument panel. The Hazard Flasher Relay is located front seating area, driver side, under dash, passenger side of steering column, mounted in fuse block.
