0
Oldsmobile Ciera
Manufactured by General Motors from 1982 to 1996, the Ciera was a mid-size car and the best-selling model of Oldsmobile. It was offered in 2-door sedan, 4-door coupe and 4-door station wagon body styles.
697 Questions
How do you repair a hood latch on a 1993 Olds Ciera S?
I assume you are talking about the hood latch cable. Replacing the hood latch itself is rather simple. Loosen the two bolts hold ing the latch in place and replace with a new or used one. For the cable, loosen the cable clip from the latch with two pairs of needle nose pliers. Attach a string to the clipped end. Inside the car where you would release your hood, you'll see two screws holding the release handle to the car. Take out these two screws and the handle should release itself. Note..you will have to remove some trim to get to handle initially but it should only be one small piece on the door side. Pull the handle and have someone else follow the string attached to the clipped end. When you get to the firewall you will have to push the bung through the wall with a screwdriver. Attach the new cable to the string and reverse the process.
What is the problem when an Olds Cutlass Ciera 3.1 OBD code reads P1406?
The P1406 code on a 1996 Oldsmobile Cutlass Ciera 3.1 is the code for the EGR pintle position circuit. I know this because it was my question initially and we bought a code reader to check the problem. It is a factory specific code, so the answer is quite specific. Good luck !
Where is the fuel filter located on a 1996 Oldsmobile Ciera?
underneath the car behind the rear driverside tire.
How do you change the ignition switch on a 1990 Oldsmobile Cutlass Ciera?
I believe you need to pull the steering wheel off and get in the steering column that way. I had this done on a previous car, (expensive) so this time I just hot wired to the starter and added a tago switch.
How do you replace the thermostat on a 1999 Oldsmobile cutlass?
The thermostat is located where the hose leaves the engine to go to the top of the radiator. You unscrew the bolts holding the hose mounting to the engine. There you find the thermostat.
The Park-Neutral Switch with the Reverse Light Relay could be malfunctioning. It is located on top of the transaxle body, in the Engine Compartment. Check to see if there is power comming through the reverse light relay plug.
My turn signals on my cutlass ciera won't work?
If the flashers work, change the fuse. It is located behind the ashtray/cigarette lighter area. You'll need to remove the cover, the fuse was a pain for me to locate when I had to change mine. But that is where mine was, and that fixed my problem. Hope this helps you.
A manifold, in systems for moving fluids or gases is a junction of pipes or channels, typically bringing one into many or many into one.
Where is the speedometer cable to a 1990 olds cutless sierra?
There isn't a speedometer cable. There is a speedometer sensor,where it is located I am still trying to find out. On the tranny or in the speedometer or somewhere else?
How do you change a thermostat on a 1989 olds cutlas ciera 3.3 liter engine?
folow your top radiator hose to the engine that is where the thermo stat will be at you will probly have to remove your air cleaner and throttle body to get at the thermostat housing
Car shakes bad when driving over 50mph?
Most likely your alignment is out of whack or bad struts. Could also be the wheels need balancing.
Why does check engine light come on and auto stalls this is a 1994 Oldsmobile royal?
Use a code reader to find out why the check engine light is on.
What are some of the reasons why a 1996 Plymouth voyager would cut off while driving?
Fuel delivery problems such as a dirty fuel filter, a fuel pump going bad, a faulty fuel pressure regulator.
How much will it cost to paint a car red?
To Paint a car red will be expensive. Red is the most expensive automotive color paint.
What might cause a 94 olds achieva to turn over but not fire?
To test for security problem, turn the ignition to the on position, and look in the dash for the security light to go off after a few seconds. If it does not go off, you can try to reset it. Sometimes this can be done by leaving the ignition in the on position for about 45mins to an hour. Do not turn the ignition off. Instead, turn the key like you are trying to start it. If it starts, you have a problem with the built in security program on the computer. Sometimes it will not happen again, other times it may leave you stranded. If it is a security problem, the best thing to do is replace the computer, or have a dealership do so.
No spark
No fuel what could be the cause does it have a security system for the fuel
No compression
You could have a slipping clutch which is not transmitting the drive correctly.
do you mean you replaced the bulb? are the flashers out on both sides of the vehicle? did you check both front and back? do the lights on the dash do nothing or come on and stay on? you need to provide this information for a proper diagnosis
88 Cutlass Ciera electric fan won't turn on at all what could be the cause?
Motor is probably burnt out
What is the cause for low beams to not work and hi beams will on a 1997 Aurora?
check fuses, then most likely need to replace the high/low switch
Why would a 1993 Oldsmobile ciera power window go down and not back up?
Most likely the window motor is dieing. If you want to replace it you can. It is not easy but it is possible to fix.
Remove the door panel. Find the motor and drill out the rivets or get the old motor out by any means necessary. Unplug the motor
Bolt in your new window motor and plug it back it. Before you replace the door panel, turn your car back on and make sure that the window motor is working. If it works replace the door panel. If not check the fit of the motor and the wiring.
takes about 3 hours your first time if you have all the tools you need and know how to get the door panel off.
the torque specs for the intake manifold are 115 inch pounds inch pounds to newton meter = mutiply .113 by the number of inch pounds aprox. 9.5 foot pounds
