0
Oldsmobile Intrigue
The Oldsmobile Intrigue was a mid-size car produced by General Motors from 1998 to 2002. This 4-door sedan was powered by a 3.8-L L36 OHV V6 or 3.5 L LX5 DOHC V6 engine with 4-speed 4T65-E automatic transmission.
1,172 Questions
Is there a better alternative to Haynes Manuals?
the manufactures manual, chilton manual,. hope it helps. duboff
With all due respect, after 60 years of auto repair and instruction, there is NO better manual than Haynes for a car owner. Manufacture's manuals are for mechanics which have had some factory training and the text often does not include information in a format which is easily understood by car owners, which is understandable. Chilton, Motor and National manuals are intended for use by professionals and often short on details, again understandable.
How do you replace the battery in a 98 olds intrigue?
Buy it at Walmart, Autozone, Pep Boys, or any number of places and they will install it for you. If you have a new battery you walked out with, perform the following in a well-ventilated area (avoid hydrogen gas buildup, which may cause the battery to explode (not fun)):
1. Disconnect the terminals and push aside.
2. Loosen the battery clamp in the base of the battery tray.
3. Remove the old battery, install the new.
4. Reattach the terminals, negative first. Be careful to avoid welding your wrench to some part of the vehicle.
Where can I find a engine schematic on line, for a 1999 Oldsmobile Intrigue 3.5 V6.
Where do you add power steering fluid to a 1998 Oldsmobile Intrigue?
The power steering fluid reservoir it is located on the front of the engine. it sits low, close to the firewall. it is very low and located on the left side almost touching the firewall in the back behind the engine. If you stand on the passenger side with a flashlight, you can see it by resting your arm on the fuse box and shining the light down and toward the firewall behind the belt. You might have to push a hose to the side to see the cap.
Where is the radiator drain cock for a 1999 Oldsmobile Intrigue?
On the 1998 Intrigue it is on the rear side of the radiator, in the lower left hand (driver) side. May need to remove the lower shroud (5 bolts) to gain access more easily.
How do you remove the engine cover on a 1999 Olds Intrigue?
Easy as pie. Remove the 2 black nuts at the front of the cover. Pull up the front edge and swivel the rear edge out of the clip that holds it down.
Meaning of dashboard warning lights Oldsmobile Intrigue?
The meaning of a dashboard warning light on an Oldsmobile Intrigue could be a variety of things. There are different lights for different things for different years of that model. It could be a service engine, check oil, sensor check, or more. The owners manual should have a listing of warning lights included in it.
What is the red symbol on Oldsmobile intrigue 98?
If you are talking about the symbol that looks like a box with a wavy line going through it, it means that you are low on coolant.
What size bulb do I need for the front headlight of a 2002 Oldsmobile intrigue?
Low beam is a 9006 bulb, high beam is a 9005.
What was the repair? Sounds like they did more harm than good. Could be disconnected. If not, there may be a blown fuse or (worse) a blown resistor in the gauge.
Where is the oil filter located on a 2002 Oldsmobile Intrigue?
Depends on the engine. 3.8L is on passenger side under a cross member to wheel well. 3.5 is on a screw-in holder on the bottom of the oil pan. The 3.8 is a traditional cannister, while the 3.5 is a replaceable cartrige mounted in the re-usable screw-in holder.
How do you remove the drain plug on olds intrigue?
Use a quarter drive socket handle, insert and turn a quarter turn. Do not force. Check out pix at http://99intrigue.shutterfly.com/headgasket/115. Go through the next four or so pix on that page. Of course, this is the radiator drain plug. If you cant do the oil pan plug, you might not want to be working on your car.
Remove AC compressor on Oldsmobile Intrigue?
.You can remove the air conditioner compressor, from your Oldsmobile automobile, by removing the compressor belt. Remove the air conditioning Freon. Remove the Freon lines. Remove the retaining bolts
Where is 99 olds intrigue camshaft sensor location?
The camshaft sensor on the 99 Olds Intrigue is located on the engine block. It is under the starter, which has to be removed to locate the camshaft sensor.
How do you change the passenger window regulator on a 1999 Oldsmobile intrigue?
You would need to remove the door panel, and them remove the splash shield from the door. Once your inside the door, you would need to unbolt the regulator from the door and also the window.
An instructional video has also been included that will show you a step by step process on how to do this.
Where is the oil filter located on a 98 Oldsmobile intrigue?
If you look under the car it is by the passenger side tire
Where is the Turn Signal Flasher Control Module on a 1998 Oldsmobile Intrigue?
The 1998 Oldsmobile Intrigue turn signal flasher control module is below the dashboard on the drivers side of the passenger compartment. The signal flasher control module should be labeled as such.
How can you get your cruise control to work again on your 94 Civic?
all you need is probly a new fuse in the fuse box.....check it and report back.
Where is the crankshaft sensor located in a 2001 olds?
It is located directly above the starter. Remove the starter and you will see it going into the side of the engine block.
How do you disable the top speed limiter on a Oldsmobile Intrigue?
You don't. It's encoded into the PCM.
Where is 1 on the injection pump on the 6.2?
Number 1 on the 6.2 GM diesel is at about the 9:30 to 10 o'clock position when looking at the pump from the firewall end. The pump turns clockwise viewed from the firewall end. The firing order is : 1 8 7 2 6 5 4 3 .
On a 1999 Oldsmobile Intrigue how do you remove the alternator?
Disconnect negative battery terminal.
Loosen the serpentine belt - loosen the tensioner.
Disconnect the alternator connections at the terminals.
Slip the serpentine belt off the alternator pulley and pull the alternator out.
Install is reverse.
