0
Turn Signals and Hazard Lights
Turn signals and hazard lights refer to the lights on an automobile designed to alert other drivers or pedestrians. Turn signals indicate where the vehicle intends to go, while hazard lights warn others of an emergency.
4,468 Questions
What do you check if the blinkers don't work?
The first thing to check is the bulbs,if one is burned out the blinker won't light up on the dash(most cars).If it lights up but does not blink it is usually a flasher unit.The flasher unit is located on the fuse panel of most cars under the dash.The flasher is round about the size of a half-dollar coin.It just pulls out from the panel.Hope it helps...JD
Obviously a fault [short or ground] in the wiring circuit(s) to these devices.
If they are on the same circuit, a single fault is probably the cause.
If they are on separate circuits, the cause could be either a single fault in a circuit which supplies power to those circuits, or there is a fault on each [unlikely] of them.
The first step is to check for a "blown" fuse. A blown fuse is generally not a "cause" of failure; the cause is whatever caused the fuse to fail.
Most people simply replace blown fuses, but a blown fuse indicates that either a short circuit or an "overload" condition has occured [causing the fuse to fail]. Simply replacing a blown fuse is much like [in medicine] treating a symptom, without treating the disease.
For troubleshooting explanations and suggestions, see answers to a similar question: "What would cause the cigarette lighter to stop working all of a sudden without the fuse being blown on a 1992 Lexus LS400."
Where is the turn signal relay located on a 2001 Lincoln?
under hood driver side, you will have to remove black cover, on back side of cover the relays will be listed
Why does flasher click when blinkers are not on?
are you sure it is the blinker? The reason I ask is I had a similar clicking noise coming from under the dash near the center console. Turns out that there is a switch under there that controls the vent door. On my 03 the switch was going bad and it would click almost identical to the blinker. The next time you hear the click try pushing the recycle air button on the a/c unit off and on several times. It worked for me. I must tell you though that my recycle air doesn't work now which leads me to believe that the switch eventually broke completely. Tweek
Nope
How do you Take off the Plastic cover to replace the turn signal bulb on the 2000 300M?
what bulb? if you need to change exterior front or rear or indicator? let me know.
Why would dash lights flash when turning on left signal indicator?
You may have a "ground loop" problem on the left turn signal. Check the ground wire at the front and rear signal bulbs.
The term 'flashers' means someone who shows or exposes his or her body parts to the public. These body parts could be either the stomach or the genitals.
Most lights on modern cars are function specific - one bulb for the brakes another for signalling, etc.... Find the bulb that is loose or blown and tighten or replace it.
AnswerPerhaps the first thing to consider would be that the bulb is burnt out or loose. AnswerThe following site discusses all lights in the Jeep Grand Cherokee, and includes pictures and diagrams on how to access them so that bulb changes can be made: http://www.wjjeeps.com/lamps/lampsrem.htm#EXTERIORREMScroll down to find specifics about removing the rear housing so that the brake light can be changed.
Answer
You might want to check your flasher relay which is under the dash.
Where is the turn signal flasher located on Dodge Ram?
Both the hazard flasher unit and the turn signal flasher unit are in the main fuse box and are identified
Where's the relay switch for turn signals on a 2002 Chevy Malibu?
If you mean the turn signal flasher it is located under the dash near the steering column.If one side still flashes, turn on that sides signals and track down the clicking sound. Often one side will quit working before the entire thing quits. Your four way flasher looks the same but it is a different circuit.
AnswerThe flasher is an electronic device incorporate with the hazard warning switch. It is selected thru turn-signal switch when "H" switch is out. It is refered to as a timer.The relay switch for your turn signals is located behind your hazard light flashers. It is literally DIRECTLY BEHIND the button used to turn the emergency lights on and off.
Audi A4-1.8T quatro Problem code P0303Any suggestions whats wrong?
P0303 Cylinder 3 missfire detected.
How do you replace the rear turn signal bulb on a 2005 Chevy Malibu Maxx?
2005 Chevrolet Malibu turn signal light bulb lamp replacement procedure: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information and full light bulb part numbers list. Then consult your owner's manual for the turn signal light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Why does the left turn signal not blink when you put your foot on the brake?
This may very well be a problem with your ground connections at that turn signal.
Why do the left blinker lights not work while the right ones do on my 1992 Lincoln Town Car?
I had this same problem with my 1994 Town Car. After closely looking (the third time) at all the lamps I finally found one that wasn't working. I found it by turning on the hazards. The tail lights have two bulbs, top and bottom. It isn't obvious that one is out when you just turn the blinker on and look, but if you turn on the hazard flashers you can compare left and right to make sure that both sides are balanced. If that doesn't do it, it could still be the flasher relay module, other bulbs, or the switch on the column. But be sure to check ALL the bulbs first. The Town Car has about 4 bulbs on each side which flash with the blinker.
Why should you use your turn signals well advance of a turn?
because if the other car that is stopped at a stop sign and you are going to turn on that street, the car stopped will know he can go.
---------
To signal is to indicate or warn. Signaling is to let the drivers around you know what you are going to do BEFORE you do it. To signal after you have already starting changing your direction is useless because other drivers will already know what you are doing... hopefully before you hit them.
It is similar to yelling "fore" while playing golf. Yelling "fore" after your ball strikes another player doesn't help them at all.
-PQ
Where is Turn Lights Relay located on Mercury Villager?
The electronic turn light flasher locates below the interior fuse block (Near to the hood release handle). Nhan Trinh of Lewisville, TX.
How do you fix turn signals on a 1995 cougar?
Well if they dont work at all i would look undernear your dash near the pedals and check your fuses cuz most the time its just a blown fuze but it might be something else i dont know
