To fix a Nintendo 64 controller that has been affected by static electricity, start by disconnecting it and removing the batteries if applicable. Open the controller and carefully inspect the internal components for any visible damage or disconnections. Clean the circuit board and connections with isopropyl alcohol and a soft brush to remove any debris or residue. If the problem persists, consider replacing the internal components or using a multimeter to check for any faulty connections.
Put oil on your controller aka the trigger
The left trigger and right trigger are the buttons at the top of the controller that you pull with you fingers
If the R2 trigger on your PS3 controller is not responding, first try resetting the controller by pressing the small reset button on the back near the L2 trigger. If that doesn't work, clean around the trigger with compressed air or a cotton swab to remove any debris. If the issue persists, consider checking the controller's connection or replacing the internal components, as there may be a hardware failure.
It's actually a M-Audio Trigger Finger not finger trigger
Well, its the white one next to the black one. If you're playing an original Xbox game on a Xbox 360, then its the left bumper (above the left trigger).
Left and Right................idk what else it would stand for. left trigger and right trigger
It means you must press the right "trigger" button which is the one that is right below the RB. The action of pressing this button simulates the pulling of a trigger.
The Z button also known as the Zed button or Zed trigger is located on the back of the Nintendo 64 Controller.
There are four triggers on an Xbox360 controller: Left and Right triggers, and Left and Right trigger buttons. LT and RT stand for Left and Right trigger and there stationed on top of the controller in front of the LB and RB buttons. LB and RB stand for Left Button and Right Button (you can also call it Left Back and Right back) and are stationed behind the LT and RT buttons.
Try pressing the Z trigger until it pops back up, it may be though to dirt inside the trigger that is causing this try carefully cleaning around the trigger.
you jump fowerds and then press B(the trigger)
I was going to try this! hehe