The issue could be due to a flow switch that prevents the heater from operating if there isn't sufficient water flow, which can happen when the filter is on if there are clogs or issues in the filtration system. When the filter is switched off, the heater may briefly detect some flow but then shut down due to inadequate water pressure or temperature readings. Additionally, there could be a malfunction in the heater's thermostat or internal components that causes it to stop heating. It's advisable to check for any obstructions in the filter and ensure the heater is functioning properly.
The warmed water next to the heater becomes hotter when the heater is switched on.
It allows air to circulate through the heater while switched on.
When an electric heater is switched on, electrical energy from the power source is converted into heat energy, which warms up the surroundings. The energy store in the heater increases as it transforms electrical energy into thermal energy.
The best water filter for a hot water heater is a sediment filter. It helps to remove particles and debris from the water, preventing them from accumulating in the heater and causing damage.
It does not have a cabin filter.
An immersion heater is used to heat water for purposes such as bathing or showering. The amount of hot water produced depends on how long the heater is switched on for.
Yes, a dirty cabin/pollen filter will restrict the ac/heater fan output.
preferred after the filter and the heater.
That'll be an airlock, bleed the heater and it will go way
Heaters are usually plumbed in after the filter. The pool filter/pump is what circulates the heated water. Ans: The heater will not work or fire if the pump is not running.
Under the bonnet, under the heater motor filter. It's difficult to get to and requires removing the filter unit. Mk4
Have you cleaned the filter lately?