You remove the wheel from axle then remove any clip holding the bearing and pop the entire bearing ( outer and inner race) out of the wheel. Take this bearing to a skate or bike shop to get an exact duplicate, or even to an industrial bearing shop to get abetter one.
bearings go inside the skateboarding wheel
The abs system will have wiring going to the wheel bearings for the speed sensors.The abs system will have wiring going to the wheel bearings for the speed sensors.
How do I change a wheel bearing
I have ran into aftermarket wheel bearings that the speed sensors do not read properly.I have ran into aftermarket wheel bearings that the speed sensors do not read properly.
How do you change the wheel bearings on a Chevrolet aveo 2005
How to remove rear wheel bearings on a 1978 corvette..?
Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier
When you take the old bearings out they should have a number on them, write that number down and take it to a skate shop, or store that sells bearings. or just take your trucks or the whole board to a skate shop they will help you out.
how do you change front wheel bearing for 420 rancher
First, remove the wheels from the chassis with a skate key/alan wrench. In the wheel hub, there should be one bearing on each side, now check the bearings to see if there is a spacer in the middle of the bearings. If there are spacers in between your bearings, you can push the spacer out to remove the bearings. If you have a mission skate key, (comes with every pair of mission skates) slide the skate key in the bearings where the axel would go, then push it until the bearing and spacer comes out... do the same with the other side. (put the spacer back in, then use it to push the other bearing out) If you have a tour skate key, (comes with every pair of tour skates) use the little nub on the side of the skate key to push the bearings out with the spacer. If your bearings do not have spacers in the middle, use a tour skate key to carefully pull each bearing out. (pull it slightly on each side like you would if you were pulling a computer chip out of a motherboard with a flathead screwdriver) If you do not have a skate key designed for removing bearings, I recommend you get one at your local pro shop or online store, otherwise you won't be able to pull the bearings out without damaging them.To put the bearings back in, just push them into the wheel hub.Do not forget to put the spacers back in if your skates require them!Weather your skates have spacers or not depends on the axel. (which is designed to fit your chassis, so don't try changing your axels on the same chassis) If you have 6mm axels, your bearings will need a spacer in the middle. If you have 8mm axels, you don't need and can't have spacers in your bearings. You may have different bearing sizes (608 standard bearings, or 688 "mini" bearings) but the process is the same.
sorry to have to tell you this but the bearings are part of the wheel hub and sealed within. you need to change the entire hub. $$$$$$$
One of the wheel speed sensor is out it is on the wheel bearings.