0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
The pool panel says the salt cell needs to be serviced it has been cleaned and reset and it still is not working The panel says salt 0000?
The pool panel has to be repaired in order to indicate the correct level of salt.
What above ground pool is the best?
a steel panel vinyl lined is probaly the most ecomical
How big should my pool solar panels be?
You would probably need a solar panel about four feet bu four feet to heat a small free standing pool. Your pool can be retro-fitted if it isn't compatible.
If you have just leased a home and cannot find the switch to turn on the pool light how can you trace it?
Pool lightCall the company or person that leased you the property and ask them where the switch is to the pool light. If they don't know; often a pool light is turned on by a breaker in the panel marked "pool light." A breaker is an overcurrent protective device, it can not be used to "switch" a light unless it is marked "SWD".
Can you use a 240 volt pool pump on normal house power?
Most typical US residences have both 240 and 120 AC voltage. The pump would have to tie into a 240 volt breaker in your electric panel. To ensure safety have an electrician familiar with pool installations install the wiring and motor/pump and also make sure that the breaker is sized for the motor amperage rating. In many pool installations a separate electric panel will be installed outside near the pump and any pool electric devices.
Can you fix it a pool control panel after it gets rained on?
Yes, although it would take a lot of time and effort it could possibly be fixed.
How efficient is solar heating for pools?
solar heating for pools is very efficient, it heats the pool with a natural resource that comes to us for free, and the only bill you will get is for the pump to circulate the water, but the pump is already going as it cleans the pool anyways.
Can you get a solar panel for a swimming pool pum what size and what you will need to install?
Sizing a solar system for a pool is relatively straight forward. First calculate the square footage of the pool (NOT the volume of water). Take that number and multiply by .8. Your goal is to get close to 80% of your surface area to be the surface area of the solar system. Buy POOL panels. Contrary to belief, panels which have a glass pane over the absorber sheet is NOT more efficient for heating pools. Set the panels facing south at 15-30 degrees of angle. A diverter valve can be used with the existing pool pump to pump the water through the panels. The 80% rule assumes that a pool cover is being used. I installed systems on the central coast of California. If your climate is cooler, add another panel. If there is no cover on the pool, increase the surface area of the solar system to 100%. Also, if you can not face the panels south, you may want to increase the panel size as well. This formula is designed to hold your pool at 80 deg. from April to October. Hope this helps
How much does a above ground pool cost to wire?
It is very important to have a licensed professional wire the filter receptacle and properly ground and bond the pool. The cost for wiring an above ground swimming pool varies depending on the length of the run. The material cost for a pool 60' away from the electrical panel is approximately $450.00 which includes a time clock. The labor for the job can also vary depending upon how clear the path is from the electrical panel to the pool filter. I would estimate the labor cost to be between $725 and $1000. So material and labor would be around $1200.00. The other thing to consider would be the cost of the permit and that will vary from $50 to $100.
What type of solar cover reel do you recommend for a 15x30 above ground pool if there is no room at either end of the pool because it is fenced?
of you put the solar panels out side the fence then u can do it. just make sure to put fence around the solar panel's
What are EasyTouch control systems?
The EasyTouchêÑÔ_ê_ÔÎ control system is a control system that use a control panel to allow the user to control or program all of the features of a Pentair pool or spa system. The EasyTouch system is also compatible with such systems as the IntelliBrite pool lighting system.
How does one join a beta testing panel?
If someone wants to join a beta testing panel for anything then one usually needs to apply in some way. They will usually have specific requirements relevant to the item or product and so will pick people from their available pool of applicants.
