Could be a bad thermostat or heater core
may be your heater control valve
Answer Trim moulding is easily removed with a heat gun. A good hair dryer might work, but a heat gun is much hotter and gets the job done faster.
The most common thing is the heater / climate control valve located in the dash area for controlling the heat output. Should be able to tell if using the dual mode changes the heat output.
System airbound? Coolant level? Temperature control cable?
They are slightly above the exhaust manifold with metal heat shields around them, but if you didn't already know that you shouldn't even have your hood open! So go to a mechanic!
check the battery. mine wont start if its 0 or colder.
Did you check your thermostat. another reason could be your heater core is plugged.
there is no heat inside the car what is wrong ?
There is no heat in my 97 buick park ave. why? the fan works an ac. an the temp says 90 degrees but still comes out cold.
Follow the top coolant hose to where the thermostat is. Just to the left of it there should be a wire. Pull the wire off and use a 19mm deep well socket to remove the sensor. Do this while the engine is cool and you will only loose very little coolant.
i think a ten liter container at 800 degrees Celsius has more heat
no