0
1999 Tahoe starter won't crank Only a click noise What should I look for?
Wiki User
∙ 14y ago
Try checking the starter relay under the hood, first. You should be able to swap it with the A/C relay right beside it. If it cranks, then replace the defective relay. If it still just clicks, then most likely it is your starter solenoid, which is mounted to and a part of most starters now. You can test the starter by jumping out the leads, but you need to have a little more knowledge about what you are doing before attempting this.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
I get a single click from the starter but it will not crank what is my problem?
your battery is dead or the starter solenoid
Will a starter crank but not start if the relay switch is bad?
Usually when a starter solenoid/relay switch is bad, you will hear only a click and the starter will not spin (crank).
Is it the starter or another problem if a 1990 ford bronco will not turn over even after attempting to jump start it?
Yes, most likely its the starter if the battery is fully charged and it still wont crank. When you turn the key, you should hear a click. That click is the starter engaging. No click, means the starter is no good.
Why doesn't my 1999 Dodge Ram 2500 with a Cummins diesel not crank Have new alternator batteries are fine and I get good voltage to the starter?
If yo have power to both wires at the starter when trying to crank, the starter is failed.
What should you check when your LTD starter will not crank but there is a click at a relay near the battery?
sounds like you need a new starter could be several things; 1. Check the battery Voltatge >10V. 2. Check the Starter and Starter Sloinoid (Take to Kragen or other parts store to test. 3. Check the Voltage coming out of your Alt. Should Be ~13V (If car is running). Does the car run if you jump it? My guess it probaly the Battery (May need charged) or Altanator not charging to proper voltage.
Where is crank sensor located on 2000 Chevy Tahoe?
it is behind the starter. You will have to remove the starter to get to it.
Where is crank shaft sensor located on 2004 Tahoe?
It is bolted in the side of the block BEHIND the starter. You will have to REMOVE the starter.
Why is your starter clicking?
When does it click and does it Crank when it is clicking
I get a single click from the starter but it will not crank what is my problem?
your battery is dead or the starter solenoid
Will a starter crank but not start if the relay switch is bad?
Usually when a starter solenoid/relay switch is bad, you will hear only a click and the starter will not spin (crank).
What makes a car not crank or click but the battery is good?
starter
What makes a Car not crank but does click?
faulty starter motor
1999 Chevy Tahoe limited and replace ignition switch and safety neutral switch and vehicle will not crank like it was in D and also replaced and checked starter relay and crank fuse tested starter?
tighten the nut from the starter to the solenoid
Where is the crank sensor on your Chevy Tahoe?
my 1999 chevy tahoe 5.7 was located in front of the oil pan, and not above the starter as so many said it would be....
Is it the starter or another problem if a 1990 ford bronco will not turn over even after attempting to jump start it?
Yes, most likely its the starter if the battery is fully charged and it still wont crank. When you turn the key, you should hear a click. That click is the starter engaging. No click, means the starter is no good.
On a 99 Tahoe If starter test good but still doesnt crank at all what could it be?
can you cranck the engine by hand
Where is the crank position sensor on a 2000 Chevy Tahoe with a 5.3?
It is behind the starter. You will need to remove starter to get to it. I WOULD CHECK TO SEE IF IT IS NOT IN FRONT OF THE OIL PAN 1ST, BOTTOM OF TIMING CHAIN COVER.. MY 1999 CHEVY TAHOE 5.7 IS LOCATED THERE... EVERYONE TOLD ME ALSO THAT IS WAS ABOVE THE STARTER. AND AFTER TAKING IT OUT . IT WAS NOT THERE;...
