where is the draincap on the radiator on the deawoo leganza 2000
The coolant drain plug for a 2002 Daewoo Leganza is typically located at the bottom of the radiator or on the engine block itself. You can find it on the lower side of the radiator, often on one of the corners. If you're looking at the engine, check near the water pump or the engine's lower section for a drain plug or petcock. Always refer to the vehicle's service manual for precise locations and instructions.
It does not have one
No. to drain your radiator just undo the main bottom hose until it is empty then tighten it back up & refill the coolant system.
The engine coolant drain plug on a Mitsubishi V6 engine is located on the bottom of the radiator. This allows for coolant to be quickly and easily drained.
To change the oil in a Daewoo Leganza, first, gather the necessary tools and materials: oil filter, new oil, an oil catch pan, and a wrench. Start by warming up the engine slightly to thin the oil for easier drainage, then turn it off and allow it to cool for a few minutes. Place the catch pan under the oil pan, remove the drain plug, and let the old oil drain completely. Afterward, replace the drain plug, change the oil filter, and refill the engine with new oil through the oil filler cap.
at the bottom of the radiator on the driver side
my drain is brok and i casn not get it out how can i drain the coolant?
To drain the coolant on a Mazda 626, locate the drain plug on the bottom of the radiator. Remove the plug and drain the coolant into a pan.
There should be a drain on the bottom of the radiator somewhere. If you cannot find one, then remove the lower radiator hose and drain the coolant form that location.
Assuming there is coolant in the engine the most likely cause is a build up of sediment behind the coolant drain or in the coolant drain tap itself.
Replacing the heater matrix on a Daewoo Matiz involves several steps. First, disconnect the battery and drain the coolant. Then, remove the dashboard to access the heater matrix, disconnect the heater hoses, and unbolt the matrix from its housing. Finally, install the new matrix, reassemble the dashboard, refill the coolant, and reconnect the battery.
Lower driver side of the radiator.