answersLogoWhite

0


Best Answer

check the ground and lead wire back to the main relay, they may be broken or arcing to the body. wires can fail over time, try re-wiring maybe.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 91 acura integra wont start changed main relay and fuel pump still has no power to itchecked if fuel pump works direct to power and it does What else should I check thanx?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When should you change the timing belt on a 1999 Acura Integra?

The timing belt on a 1999 Acura Integra should be changed every 75,000 miles. Once over the mileage limit there is a chance the belt will fail causing engine failure.


What is the engine oil capacity for a 1995 Acura Integra?

Approximately 4.5 quarts on a 1996 Integra GS-R (So it should be close for the '95). Approximately 4.5 quarts on a 1996 Integra GS-R (So it should be close for the '95).


Where is the ecu in an 1992 Acura Integra?

should be under the passenger floor


How much shoud it cost to replace an alternator for your 1988 acura integra LS?

Hou much should it cost to replace an alternator for a 1988 acura integra Ls?


When should a timing belt be changed in a 1990 Acura Integra?

It should be done every 6 years or 90,000 miles... so it should have been replaced 2 times already hopefully... if in doubt have it replaced... if that little belt rips you will Destroy valves and pistons... basically total engine detonation...


Will a automatic transmission out of a 93 Acura Integra work in a 91 integra?

Yes it should. Im 99% sure it will. you might want to double check the part number to see for sure. i have a 1990 Acura integra and i have used many parts from integras from 1990- 1993.


Where is the transmission filter on a 1991 Acura Integra GS?

Should be located inside transmission pan.


Where is diagnostic port for 97 integra dc2?

Should be under dash somewhere driver's side.


91 integra throwing code 4 Its a crank sensor whats insdie a dizzy. changed that and ecu still throwing a code 4. what else could it be?

you have to reset your ecu. disconect the battery of take out ecu fuse for a couple sec then code should be cleared


Where is the thermostat located on a 1994 Acura Integra?

changed mine today its close to the starter follow the bottom rad hose to the block theres two bolts 10 mm should do it take of air intake and remove heater hose from head just to get it out the way


Should love be direct or indirect?

It depends on who you are, in my opinion it should be direct.


Where is the Thermostat on a 1991 Acura Integra?

Should be a in a removable housing at the engine end of the upper radiator hose