power i.e current and voltage or ammeter and voltmeter
No, on dc the power is measured by the produce of the voltage and current so there is no need for a wattmeter, which would not work on dc anyway.
No
nothing
bungaw..
The 'one wattmeter method' can only be used for balanced, wye-connected, loads where the load's neutral point is accessible. The wattmeter's current coil is inserted into any line conductor, and the voltage coil is connected between the same line and the neutral point. The wattmeter reading indicates the power of one phase, so the total power is three times the wattmeter reading.To measure the total power of a balanced or unbalanced wye- or delta-connected load, it is only necessary to use twowattmeters -this is called the 'two wattmeter method'. In this case, the current coils of each wattmeter are inserted into any two line conductors, and the voltage coils are connected between the two line conductors and the third line conductor. The sum of the two wattmeter readings will indicate the total power of the load.
this works with both.
No, on dc the power is measured by the produce of the voltage and current so there is no need for a wattmeter, which would not work on dc anyway.
The advantages of wattmeter include adequate for low frequencies, easy to operate and better technology. There are different types of wattmeter and each has specific advantages.
The wattmeter was invented in the late 19th century by Oliver B. Shallenberger in 1888.
No
nothing
bungaw..
5V dc motor is the best for the robotics materials and it is inexpensive as compared to the other motors. dc motor is made up of the magnetic coils consist north and south pole
JAMES WATT
221
Blondel's Theorem states that you can have one less wattmeter than there are conductors supplying a balanced or unbalanced load. In either case, the sum of the wattmeter readings will give you the total power of the load.
The Roman numeral for the number 600 is DC (D = 500 and C = 100, so DC essentially means 500 +100).