flywheel
Answer 1It is a sensing device which detects each revolution of the crankshaft, and the rotational position of the crankshaft at any given time, in order to provide that information to the engine computer. The computer then uses that information as a reference upon which to base ignition timing adjustments.It reads the position and/or speed of an engine as it is rotating.
If the crankshaft sensor is dead the engine will not start
crank-walk is when a cars crankshaft begins to move in directions it wasnt designed to move an the out come can be desaterous to your cars engine
No,the engine is designed to be no interference.You can turn the crank or cam without damage to get it in time.
The length of the crankshaft throw is the stroke of the engine.
Looking at the front of the engine. The engine/ crankshaft will turn clowkwise.
The crankshaft converts the linear motion of the piston into rotation of the crankshaft.
The crankshaft is located inside the lower half of the engine. The engine must be removed and disassembled to gain access to the crankshaft.
It is on the front of the engine on the end of the crankshaft.
The crankshaft is the largest part in the bottom of the engine.The crankshaft is the largest part in the bottom of the engine.
It's located behind the crankshaft pulley bolted to the engine block.
A crankshaft is the part of the engine that the linear piston rotates. The amount of turns in a crankshaft to complete 1 revolution in a V6 engine is four.