answersLogoWhite

0


Best Answer

no, you do not need a compression tool to remove or replace them

User Avatar

Wiki User

โˆ™ 2005-11-18 07:38:52
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Are the springs on a 1988 Pontiac Grand Am pressed on?
Write your answer...
Submit
Related questions

Is there a CD player for a 1988 grand prix?

No, Pontiac only offered a cassette player and AM/FM radio in 1988.


Is a Pontiac grand prix front wheel drive?

The Pontiac grand prix became front wheel drive in 1988-present. Before '88 it was rear wheel drive.


Clutch slave cylider location on a 1988 Pontiac Grand Am?

In a 1988 Pontiac Grand Am you will find the clutch slave cylinder located on the flywheel. You will need to remove the hush panel from the driver's side foot well to gain access to the clutch slave cylinder.


How do you replace the alternator on a 1988 Pontiac fiero?

How do you replace the alternator on a 1988 Pontiac Fiero


Where can you find the electrical schemantics for a 1995 Pontiac Grand Prix SE?

There are decent diagrams in Chilton's GM Lumina/Grand Prix/Cutlass Supreme/Regal 1988-96 repair manual.


When was Willow Springs Center created?

Willow Springs Center was created in 1988.


What would cause the speedometer on a 1988 Pontiac Grand Prix read 100 mph when the car is only doing 55?

Make sure it is not set for Km


How do you remove the rear seat in a 1988 Pontiac Grand Am?

there are 2 bolts located near carpet on the front of the lower rear seat.remove them... then, seat should lift out.. !!!!!


When was Colorado Springs Sky Sox created?

Colorado Springs Sky Sox was created in 1988.


What is the valve calibration order on a 1988 Pontiac Grand Am?

the same as the firing order set all your intake valves then go thur again and set your exh. valves.


What is the firing order for a 1988 Pontiac Le Mans?

The firing order for the 1988 Pontiac Lemans is 1-3-4-2. I hope this information to be useful to you


How do you change the front wheel bearings on a 1988 Topaz?

They are pressed in and need to be either pressed out and in on the vehicle or remove the spindle and brought to a press to do this.


From what years were Pontiac fieros made?

1984-1988


Troubleshoot headlamps on 1988 grand marquis?

troubleshoot head lamps on 1988 grand marquis? Not working...fuses OK


Where is fuse for tail lights in 1988 Mercury Grand Marquis?

where is the fuse for tail lights in 1988 mercury grand marquis


How do you remove the ignition switch on an 88 Pontiac Bonneville?

I have to jump start my Pontiac Bonneville 1988 everyday I drive it why is that.


Will a 1979 Pontiac 403 engine fit 1988 Chevy Camaro rs?

Pontiac did not make a 403 but offered a Oldsmobile 403 in the trans am, lots of work and modification to put in a 1988


Doesmy 1988 Monte Carlo ss have shocks or struts or springs?

You have coil springs front and rear as well as shocks.


What actors and actresses appeared in Le grand jour - 1988?

The cast of Le grand jour - 1988 includes: Roy Dupuis


Where is the temperature sensor located on a 1988 Pontiac trans am?

intheintakemanifold


What is a 1988 Pontiac GTA 5.7L V8 tbi engine?

It is a Pontiac Firebird Third Generation produced from 1982 - 1992.


What is the firing order for a 1988 Pontiac Sunbird?

The firing order of my '87 Pontiac Sunbird is 1 3 4 2.


Where is the starter located on a 1988 Pontiac Grand Prix?

If it is a 6-cylinder engine the starter is at the "front" of the engine about 10 inches behind the bottom of the radiator. You have to jack up the front of the car and remove it from underneath.


How do you change the timimg belt on 1988 mercury grand marquis?

NO belt in the 302cid engine of a 1988 Mercury Grand Marquis. it is a chain with gears


When was Pink Grand Prix created?

Pink Grand Prix was created in 1988.