Ball Joint Replacement: I used the rental tool to press out the old ball joint and press in the new one. When pressing out the old ball joint the key is to properly set up the press, tighten the screw on the press, then give the screw a few good solid blows to shock the old ball joint. Once I did this the old ball joint pressed out almost effortlessly. Installation of the new ball joint was a breeze. The only comment is be extremely careful not to damage the axle boot seals. Have wire on hand to tie the spindle assembly and axle for support to prevent damage to the brake hoses and ABS system.
Replacing Ball joints Check Related Links Below
you will probably need a ball joint press and a splitter
There are no king pins on these models.....if my memory serves correct they stopped using kingpins either in 79 or 80.....ball joints is what they switched to
kick it between the legs and hope it dont bite back.
how to replace an oil pan that goes to a ford f150 1993? how much does the pan cost,and can you show a picture of it?
Front springs are sagged out, camber is out(kits for upper ball joints available) or something is worn out or bent.
Yes.
There is not a good and clear indication on how many ball joints are on a 2000 Ford Mustang. After searching around, there are conclusions that there are at least two ball joints on the Mustang.
There is no OBDII connector on 1993 F150. Didn't start until 1996 (97 model).
please answer my question on how to replace ball joints 2007 ford sport track?
What question
ball joints are parts of the front suspension. outside of the A-Arm