Longest to shortest line
R-R, L-R, L-F, R-F
If the brake pedal is soft on a 1997 Ford F-150, then there is a good chance that there is air in the brake line. This can be remedied by bleeding the brakes system.
7.99 at autozone you have to order it .
If the brakes are not working on the back of a 1997 Dodge 1500 after changing the brake pads, try bleeding the brakes. The fault may also be with the master cylinder under the hood. Check to make sure all brake lines are connected.
On the brake pedal.
To put brake fluid in a 1997 Ford Explorer, you must locate the brake fluid reservoir. Once you locate it, unscrew the cap, and replenish the brake fluid.
are brake lights staying on or is brake in the dash on ?
Begin by removing the tire and wheel from your 1997 Toyota. Remove the brake spring and the brake caliper. The brake pads will come off. Reverse the process to install your new brake pads.
where can i find a diagram for a 1997 chevy s10 brake switch?
Brake light fuse
The red brake light on the dash means that the brake fluid is low or the parking brake is on.
It is important to have a diagram when making a change in the brake lines. A diagram for the 1997 Expedition 4wd brake line can be found in maintenance manual of the car.
check your clutch and brake fluid
is your e-brake on?
It's on the arm of the brake pedal.
How do you change front brake hose on a 1997 lincoln
For a 1997 Mercury Sable : ( DOT 3 brake fluid meeting Ford specification ESA-M6C25-A )
you might check the brake light switch because that has to be on in order to get into gear. There are two switches on the brake pedal. one for brake lites and one for cruise control.My 97 had the same intermittent problem and I found a loose wire on the brake switch.
behind the brake pedal
DOT 3 brake fluid
Above the brake pedal,its black plastic.
the brake light driver side not working
Check your brake fluid level!
The 1997 Pontiac brake light fuse is located in the fuse box. The brake light fuse will be labeled as the tail light fuse.
The 1997 Chrysler Sebring parking brake cable has adjustment nuts on each end of the cable. Adjusting the nuts will lengthen or shorten the parking brake cable.