Crankshaft Sensors
Chevy Camaro Z28

Camaro 1999 z28 crank position sensor?

8910

Top Answer
User Avatar
Wiki User
Answered
2009-01-01 03:00:30
2009-01-01 03:00:30

how do you change a crankshaft position sensor on a 1999 chevy camaro z28?

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


The 1999 Chevrolet Alamo crank shaft position sensor is located on the back of the engine. You will need to remove the rear engine cover in order to access the crank position sensor.


I can not find where is located the position of sensor crank of 1999 nissan sentra 2.0 ( in what point is located in the motor)


I would like to know where the cam sensor is on a 1999 pathfinder and is there one or they calling it a crank shaft sensor The cam shaft position sensor is located in the distributor.


The crank shaft positioning sensor is behind the starter. A real bear to get to.


Never heard of an "ignition sensor". Do you mean oxygen sensor, or maybe crank position sensor, or cam position sensor? There is an ignition "module" also... The oxygen sensor is on the exhaust manifold. The crank posiiton sensor is on the backside of the block. The cam position is on each head.



Doesn't have one, only uses a crank sensor.


how much cost a crank sensor for a intrepid 1999


No, the crank sensor reads crankshaft speed. The cam sensor reads camshaft speed. The cam sensor is on the distributor on a 1999 2.5L


a kia 1.8 have crank sensor yes or no


The crankshaft position sensor is mounted in the top driver side of the transmission bell housing.


The crankshaft position sensor is at the rear of the engine where it joins with the transmission bellhousing. It is at the left (front) side, not far from the starter.


The crank sensor is behind the starter. Remover the starter at the back of the engine and you will see the sensor


The 1999 Range Rover 4.6 liter engine crank shaft sensor is located on the back of the engine. The crank shaft sensor is behind the rear engine cover.


There is no "camshaft position sensor" in the 1999 ranger 2.5l motor so they have to have a crank position sensor. what kind of problems are you having? i might be able to help. you can email me at cmjbrodman@gmail.com. I have a 99 2.5 with a P340 code "camshaft positioning sensor circuit malfunction" Supposidly, it is behind the aux pulley.


the sensor is in the front timing cover of the engine on pass.side above the crank pulley,10mm wrench will remove


were is the camshaft position sensor on 1999 Volvo s80 turbo


Try looking under the starter.


I have a 1999 Catera. When this happens it is almost always the crankshaft position sensor. Check on www.cadillacforums.com for more info.


The CPS is located on the front of the engine attached to the harmonic balancer on the front of the crankshaft.


The first thing I would check is your crankshaft position sensor



where is the camshaft position sensor located on a 1999 Oldsmobile intrigue


Lock up, No but a bad crank sensor will prevent the engine from starting.


how to remplace position of oxigen sensor



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.