If it is an incandescent bulb with the standard Edison base it will fit.
An A19 shaped globular bulb with an E26 base is the standard bulb that has been used in homes for the last few decades.For a chart see related links below.The A19 refers to the type of and size of the bulb base and socket. There are a myriad of different bulb shapes, but they need an A19 base to fit an A19 socket (standard light socket).
It could fit a T10.
I believe that the light bulbs are located in the trunk lid and are basic 1156 bulbs but they fit into a bulb holder that fits into the housing with a twist and turn motion.
If both bulbs fit into the same socket I would presume this to be fine.
It is a type of array to fit into an intel Socket 370 or Socket 478 CPU socket.
You pick a socket to fit the nut you want to move and fit that socket onto the ratchet tool and turn it to loosen or tighten the nut.
You standard size light bulbs will fit into them, just make sure they are the right style.
You fit a screwdriver bit in a 1/4 socket.
Yes, both fit in the PGA 478 socket. SeanHolshouser
The microprocessor is installed into the CPU socket on the motherboard. A CPU socket can only fit a certain range of microprocessors.
Could buy your new plugs to make sure your size is correct. Then you might have to go and get a deep socket of that size and the extension will just fit(but not click)into the top of the socket if you hold it right.Or grind down the fat socket!
Acetabulum