Depends on the solid object. Generally, yes. A magnetic material (steel, iron etc.) offers some shielding while a superconducting magnet offers I believe perfect shielding.
Fridge magnets work just fine through paint, paper etc. It's the thickness of paper pushing the magnet away from the door that stop you holding up a book, not that the magnetic force is stopped by the paper.
No. You'll end up with two smaller magnets, and each will have less than half the magnetic field strength of the original magnet.
Yes, each half still has magnetic properties.
Use a magnet to remove the iron, a filter or screen to remove the sand, and a still to remove the salt.
Magnetic materials are notoriously hard so you will damage an ordinary hacksaw blade if you cit a bar magnet with a hacksaw (but you should eventually succeed if you do not mind dulling a few blades). An angle grinder with a metal cutting disk will work but magnetism is destroyed above the Curie temperature (about 500° C) so you should cool the magnet often as you cut through it (beware of sparks and bits flying off - wear protective clothing, ear and eye protection!).
The point at which a liquid becomes a gas is the boiling point. The point at which a gas becomes a liquid is still called the boiling point. A solid going straight to gas without passing through a liquid state is called sublimation. Dry Ice solid CO2 is a substance that that sublimes.
anything. water, land...solid waste still is pollution and carries chemicals.
300 degees C --- That's not even its curie temperature. Not only will it still be solid, it will still be a magnet.
its a solid because gases spread out< liguads move slightly and solids stay still
yes.when you slice a rod magnet it will still be considered as a magnet
No.If you break the magnet, it is still a useful magnet.
No. You'll end up with two smaller magnets, and each will have less than half the magnetic field strength of the original magnet.
Magnetism CAN pass through fruit juice. If you were to use a bar magnet on the table attracting another magnet on the other side, it would still attract. Magnetic studs are a good example of magnetism because they can stick/ connect together even through the flap of the ear.
It is so far experimentally impossible to separate the North Pole from the South Pole. Even if you cut the magnet into little pieces, it'll still remain a magnet because there will still be a North pole and a South Pole
No, being a magnet, it has a north pole and a south pole. The two can't be separated in a magnet. If you cut the magnet in half, each half will still have a north pole and a half pole.No, being a magnet, it has a north pole and a south pole. The two can't be separated in a magnet. If you cut the magnet in half, each half will still have a north pole and a half pole.No, being a magnet, it has a north pole and a south pole. The two can't be separated in a magnet. If you cut the magnet in half, each half will still have a north pole and a half pole.No, being a magnet, it has a north pole and a south pole. The two can't be separated in a magnet. If you cut the magnet in half, each half will still have a north pole and a half pole.
No , because in everything is made out of atoms. even us humans. Atoms are tiny masses and there always moving . now solids are still. therefore, can it be a solid?by shallie asembo and Gary Robert
Yes
Yes, each half still has magnetic properties.