Yes, but you have to use connectors designed for that purpose. Using ordinary wire nuts could cause a circuit failure due to a high resistive junction.
It can be done with approved connectors Make sure that the connector is approved for Al-Cu wire connections.
When compared by volume, copper is best, then aluminum and finally iron. When compared by weight, aluminum is better than copper. You have to compare by volume because aluminum is so much lighter than copper, an aluminum wire that weighed the same as a copper wire would be much bigger and harder to work with.
Mostly aluminum because they are ran in free air and that changes their ampacity rating enough for aluminum to be more economical than copper. Gold has a higher ampacity rating than either al. or copper but it is to valuable to leave hanging in the air.
If the wire used is aluminum, just a small movement of this wire can cause a brake. Aluminum wire ran under a drive is an area I have seen a problum. If ran under a drive than it should be in concuit. With copper or aluminum the wire may have been nicked when it was installed. This would caues corrosion and a brake after some time.
Gold,silver,copper, aluminum are good conductors of electricity, in that order.Aluminum is cheap and widely used for most purposes.Copper is used for winding of motors and also house internal wiring if you can afford it.
Splice uses stranded wires while joint uses solid wire.
Yes as long as you use an approved splice, such as a wire-nut.
Copper is preferable to aluminum and the size of wire should be the same or the next size down if copper is used.
No, it is not recommended to splice copper and aluminum wires together on a 240 volt system. Copper and aluminum have different expansion rates and electrical conductivity properties, which can lead to loosening connections and increased risk of overheating or electrical fires. It is best to use connectors specifically designed for joining copper and aluminum wires or alternative solutions like using a pigtail or replacing the wire entirely.
In the electrical trade aluminum wire is equivalent to copper wire as it is also used to carry current. To carry the same current as copper wire aluminum wire is up sized to meet the same ampacity.
Copper and aluminum used for electric wires
an alloy
No, do not mix aluminum wire with copper wire.
Copper or aluminum wires.
Aluminum and Copper Wire
Aluminium wire has high resistance than Copper.
An Electrical wire is used to flow the electrons from one point another point . Copper or aluminum is insulated with polythine is called wire
When compared by volume, copper is best, then aluminum and finally iron. When compared by weight, aluminum is better than copper. You have to compare by volume because aluminum is so much lighter than copper, an aluminum wire that weighed the same as a copper wire would be much bigger and harder to work with.