0
No. Your stopping distance will almost double.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Why are the rear brakes on a jeep wrangler used more than front brakes?
becasuse its a rear wheel drive vehicle
Where on the vehicle can a parking brake be installed?
The rear brakes is the normal location but it could also be the front or on the drive shaft on a rear wheel drive.
Where on a vehicle can a parking brake be installed?
The rear brakes is the normal location but it could also be the front or on the drive shaft on a rear wheel drive.
Can you change rear drum brakes on a subaru 1.6 4 wheel drive for disc brakes?
Not worth the effort and expense
Does a front wheel drive town and country van have rear brake pads?
They have rear drum brakes up through 2000. 2001 and later should be disc brakes.
If you drive with your e-brake on will that mess up your power steering?
No, but it will wear out the rear brakes.
How do you install rear brakes on gmc SUV 4 wheel drive?
take it to a mechanic
In 2004 Toyota Camry if I have not used hand brakes do I need to replace front and rear wheels brakes or just front wheel brakes?
Rear brakes do not have to be replaced too often. It's really hard to tell without looking at it. What you can do is to replace front brakes and test drive it, if you feel that your car brakes works just fine you do not need to replace rear brake shoes.
Does a ford ranger take 9 inch brakes or 10 inch?
Depends on your Ranger, the non 4 wheel drive take 9 inch rear brakes. The 4 wheel drive Rangers take 10 inch brakes.
What do you need to do to drive your truck with out back brake pads?
You need to replace the rear brake pads and anything else the brakes may need. Driving without rear brakes would be foolish and dangerous. Good brakes are a number one priority.
How do you bleed breaks on 99 Yukon?
you have bleeder valves on all brakes. look for small fittng usually on back side of brakes starting with rear passenger side crack the bleeder valve and have someone slowly pump the brakes wait to see if all air is out tighten when fluid is steady and NO air bubbles. rear pass to rear drive then front pass and then of coursefront drive
What percentage of the braking force comes from the rear brakes in a typical front wheel drive vehicle?
If memory serves, the typical braking force ratio for any automobile with front disc and rear drum brakes is 60% front, 40% rear +/-.
