0
This idea is not economic.
It would cost more to convert it safely than buying one or more single phase heaters (either second-hand or new) to give the same heating effect.
3-phase heaters are not usually intended for domestic use in homes, except for the latest new-builds which have 3-phase supplies. They are commonly used in industrial sites (factories, workshops, etc.) or large public areas (department stores, airline terminals, etc.) where a 3-phase power supply would be installed as standard at the site.
<><><>
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
Wiki User
∙ 14y ago
Wiki User
∙ 12y agoNot knowing the design, I would say no, at least not easily. The 3-phase system can deliver three times the power under normal conditions.
Add your answer:
Earn +20 pts
What is kando system?
it convert the single phase in to three phase.
You switched leads on your 3phase motor and it did not reverse?
Then it is not a three phase motor.
How do you wire a 1 to 3 phase roto verter?
How do u wire a 1 to 3phase rotoverter
Convert single phase to three phase formula?
I'm not sure what your question means as a single phase supply is normally one of the phases and the return/neutral, not all 3 phases converted to one, plus return.
What would be the amperage draw of a single phase 1200 watt heater if voltage is 120?
10 Amps. Amps=Watts/Volts
How convert 1 phase to 3phase in aircraft?
The power is generated in the form of three-phase in aircraft, and this sytem has no problem in feeding single phase loads. To conserve mass in tansformers and motors the supply works at 400 Hz.
Can you get 180 degree single phase power from 3phase?
Rephrase your question so that it makes sense.
What is name of motor having 3phase winding single phase winding with permanent magnet and a tachogenerator?
Its a servo.
Can I convert Single phase to three phase for resistance heating?
Single phase can't be turned into 3-phase by any reasonable means. But on the other hand resistance heating is fairly straight forward. If only the fuse rating is high enough it might be possible to rewire a 3-phase heater to run from a single-phase source.
Does a two phase heater need a two phase thermostat?
Most electrical equipment are either designed to work on Single phase (two wires) or Three Phase (three or four wires). Two phase equipment are non existent today. A single phase heater will require a single phase thermostat while a three phase heater will require a three phase thermostat.
Can you convert a 3 phase convection oven to single phase?
I dont know if you can actually convert the oven's wiring from 3-phase to single phase. You can, however, convert the single phase circuit that will feed the oven to a 3-phase system. To this you will need a phase converter. Now, where to purchase such an item, and how much they cost? i have no idea.
How do you convert a 3-phase system to a single phase?
By having a transformer with 3 phase input and single phase out put
What is kando system?
it convert the single phase in to three phase.
Can you wire up a 240 volt single phase water heater to 277 volt single phase?
no
Is it possible to convert a 2.4 kw single phase appliance to a 9kw 3 phase appliance?
No, it is not possible to convert a 2.4 kw single phase appliance to a 9kw 3 phase appliance. Single phase can not be converted to three phase with out considerable cost involved.
Can you convert a single phase power supply into a three phase stabiliser to power a home?
Houses generally run on single phase power. It would not make sense to convert single phase to three phase to run a house. Please restate the question.
How many microfarad of starting capacitor is best for 15hp 3phase motor?
Starting capacitors are only required for single-phase induction motors. They are not necessary for three-phase motors.
