0
I've got a 2006 F-350 KR and I do it all the time ! I don't believe it is connected to the truck circuit ! I wouldn't leave it on there after the truck has started ! ! ! !
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the crankshaft position sensor located on a 2000 dodge ram 2500 5.9 diesel model automatic?
On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.
Where is the crank shaft sensor on a 2000 Dodge Cummins Diesel?
It is in the side of the block behind the starter.
If a 97 cat 3116 had excessive blow-by through crank case vent tube and was hard to start when set overnight but you plugged block heater in heavy smoking stopped while idling and engine started right?
Did you overfill the oil?
Where is the crank shaft sensor located on 1999 dodge 2500 5.9 diesel?
It is in the side of the block, behind the starter.
Where is the crank sensor on a 1999 Dodge Ram 2500 with a 5.9 L diesel?
It is in the side of the block, behind the starter.
Where is the crank sensor located on a 6.0l ford power stroke diesel?
where is the crank sensor located on a 6.0l ford power stroke diesel
Where is the crank shaft sensor loacted on the engine for 1996 F-250 7.3 diesel?
The crank shaft sensor is located on front of block above the harmonic balance wheel (bottom pulley on front of engine). This is easiest to get at from underneath the vehicle.
Where is the crank sensor located on a 2001 dodge ram van?
GAS ENGINE The sensor is mounted on the bellhousing DIESEL ENGINE Bolted to the left rear side of the engine block
Can you put a big block crank in small block 400?
No
What is the difference in horsepower in a 360 and 318?
crank, & heads, same block different stroke crank, & heads, same block different stroke
Where is the RPM sensor on a 2006 diesel golf?
crank sensor
Where are timing markspeugeot 206 diesel?
the cam is locked @ 4 oclock the pump @ 12 o clock and the crank is a pig use a Alan key and place it in a hole in the fly wheel under the starter motor or take out number 1 heater plug get a welding rod and put it in the heater plug hole then tunrn the crank over by hand slow until number 1 piston is on tdc.
