0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What tool drills holes?
A drill bit (hand or machine) is designed to drill a hole through either wood or metal material.
Is it possible to drill a hole from North Pole to South Pole through the earth 7900miles?
Physically, this may be an impossibility, given the material you'd be required to drill through, including the Earth's molten core.
How is a masonry bit used?
Masonry refers to brick and cement. If you have to drill a hole in that kind of material, just put the masonry bit in your drill, and you can drill the hole in exactly the same way that you would drill a hole in wood, it works the same way.
Can you drill a hole through a diamond?
Yes
What must you use to hold the acrylic firmly so that you can drill safely?
To drill your material safely using the pillar drill you have to stand not too far away from the machine so then you can quickly turn off the machinery when you've made your hole through your material (e.g: Wood, Metal etc...).
What is the definition of a bore?
To make a hole in or through, with or as if with a drill.
Can I drill a hole in glass?
Yes, but not with the usual drill bit. Drilling a hole in glass is accomplished with an abrasive that actually wears a hole through the glass.
What size drill do you use for a five sixteenth inch dia lag screw?
It depends on the material you are fitting it into. In most wood I pre-drill a 1/4 hole for this. In softer woods i would drill a smaller hole .
How do you run cables through wall studs?
Drill a hole through the board
What is the difference between impact drill and hammer drill?
Nothing. Both work on the principle of 'hammering' a hole through a material (usually masonry such as brick or concrete) through the action of a drilling action to remove debris and the hammering which breaks down what the drill twist cannot purchase itself. The 'impact'referred to is caused by a cam within the drill that aggressively vibrates the chuck and bit to 'hammer' the material. Twist bits 'carve' out material whereas hammer or impact drills pulverise.
How do you modify a Nerf shell?
You will either need a hammer and a nail or a drill, for the drill find the small hole in the back and drill through it until you can see through it. For the hammer put the nail in the hole in the back and keep hammering the nail until the orange stick comes out.
What tool will be used drilling hole in plasterboard to fit a 15mm copper pipe through?
15mm drill bit and a drill.
