Yes, remove the door panel, remove the window motor. You should be able to lift the window up.
It cannot be raised manually. You will have to repair it in order to raise the window.
I had to to take the door panel off remove the window motor raise the window then put the motor back on
take the door panel off and disconect the wire assembly or window regulator that goes to the power window moter and manually pull the window up.
You have to disconnect the glass from the regulator or clip the regulator cables.See this post for instructionshttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-regulator
How do you manually raise the power windows on chrysler sebring?
No, not without removing the door panel to gain access to the motor unit.
the only way i know is to disconnect or remove the motor and manually move the window up until the motor is replaced. sometimes also it could be just the switch.
No.
try removing switch, and jumping the wires, this should raise window with out pulling door apart
Run a wire from the POSITIVE terminal on the battery and touch the red wire (positive) to the window motor and run another wire from the NEGATIVE terminal on the battery and touch the green wire (negative) to the window motor. The window should go down. Reverse the wires to make the window go up.
Run a wire from the POSITIVE terminal on the battery and touch the red wire (positive) to the window motor and run another wire from the NEGATIVE terminal on the battery and touch the green wire (negative) to the window motor. The window should go down. Reverse the wires to make the window go up.
Other than taking the door panel off and disconnecting the window from the regulator, there isn't any way to raise it manually.