The light bulb needs to match the ballast in the fixture.
As in all electronics heat is the culprit..if a lamp is mounted (let us say at a ceiling in a warehouse the temperature at the ceiling area is always more than the ground level) and this becomes a cause for ballast failures. Voltage spikes and dips are also a reason for ballast failures. The ballast specifications should match with the lamp (undersizing it will also cause failures) eg. using a 32 watt ballst for a 40 watt lamp. Cheers. Chaterpilar
$250
48 lbs
Look i have a 5500 watt power acustic amp and its saids not to use nothing under 0 gauge. So use that thicker wirer mean better performance. Try it!!
i found one for 65.00 new
Yes assuming the ballast is also for a metal halide lamp.
6000lm
No, the ballast has to be matched to the lamp. 250 watt ballast, 250 watt lamp. Also be sure to match the lamp type to the proper ballast even though the wattage is the same. HPS ballast to HPS lamp, Metal halide ballast to metal halide lamp and mercury vapour lamp to mercury vapour ballast.
No. A 70 Watt metal halide bulb can not be replaced with a 150 Watt halide bulb.
Yes, the ballast is an intricate part of the fixture that the lamp screws into regardless of what size wattage the lamp is.
No. The bulb has to match the ballast wattage exactly. And you can't interchange different lamps (like metal halide) either. The ballast is specific to that wattage and lamp type. The bulb will either burn out quickly or just not work properly at all
I actually have a 400w hps ballast and I can also use my 400w metal halide bulb in it with no problem. So what your saying is they do, but they dont? the answer is, they dont. You can get universal bulbs hps to plug into a mh ballast they have a miniturized igniter inside the bulb. As I understand it, a 400W metal halide bulb can be used with a 400W hps ballast, but not the converse. A MH bulb has the igniter in the bulb, and the HPS has it in the ballast--which pretty much goes along with your comment above. Apparently the double presence of the igniter in the HPS setup is OK.you can run metal halide in same wattage's but not hps in metal halide systems.you can run such as (same wattage's)250 watt metal halide-400 watt halide ect in hps systems but not hps bulbs in halide systems. they make conversion bulbs to run halide in hps as well and vice versa.
It will power two 400 watt lamps.
400 watt metal halide fixtures can be purchased at various sites on the internet. Some sites that you may want to try out include the following: Amazon and Home Depot.
Yes.
A 230 watt linear halogen lamp should be replaced by a 230 watt linear halogen lamp if the same brightness is required.
From 20,000 to 23,000 lumens depending on the brand.Average figures:Incandescent: 10 lumens per wattHalogen 13 lumens per wattCFL (low-energy) 50 lumens per watt