answersLogoWhite

0

The compressors are basically the same . Very simply put with out getting to technical is what makes a heat pump a heat pump is a reversing valve that changes the direction the refrigerant travels in lines leading to and from the condensing unit and to the coil, without changing direction of flow in they compressor. You should always check with the manufacture before replacing an unlike compressor for compatibility.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you clean heat sink in CPU?

Air Compresser


What is compresser oil?

Compressor oil is a specialized lubricant designed for use in air compressors and refrigeration systems. It helps reduce friction between moving parts, enhances efficiency, and prevents wear and tear. Additionally, it plays a crucial role in dissipating heat and protecting against rust and corrosion. The formulation of compressor oil can vary depending on the type of compressor and its intended application, including synthetic and mineral oil options.


When recovering refrigerant into a non pressurized container from a refrigerator with an inoperative compressor?

it is necessary to heat the compressor and strike it with a rubber mallet!


Can you heat a car without running the compressor?

In a car the heat usually comes from engine "waste heat". You just need to be running the engine. The compressor is part of the air conditioner, which is used for cooling not heating.


Why does my home air conditioner only blow heat?

Your compressor has possibly stopped working. If you are lucky, the serviceman will only have to replace the freon to get it going again.


What is a compresser in a car?

A compressor in a car is a crucial component of the air conditioning system. It compresses the refrigerant gas, increasing its pressure and temperature, allowing it to circulate through the system and absorb heat from the cabin. By facilitating this process, the compressor helps to cool the air that is blown into the car's interior, providing comfort for passengers. Additionally, it is typically driven by the engine via a belt, engaging only when the air conditioning is activated.


Is it a wise choice to replace a compressor in an 11 year old Carrier 42k BTU heat pump rather than replace the whole outside unit?

No it's not. But if that's all you can afford then, you have to put the compressor in. You will have a one year warranty on the compressor. If you have a new system put in you can get a ten year warranty on every part. Goodmans and Amana, also have units with lifetime warranties.


How do you identify a heat pump from outside appearance?

Looking through the top by the fan . Look at your compressor if its a heat pumpbyou will have a accumalator which looks like an long can which your copper line runs to and you will also have a reversing valve which is attached in your line sets it will have three copper lines running to it and an electrical line to it also. A straight cool unit you will see nothing but a compressor. Also if your thermostate has a emergency heat most likely its a heat pump.


How much should it cost to replace heat pump compressor?

A full day service call plus the cost of the compressor, refrigerant and new driers.Plus perhaps disposal charges of the old one since it contains oil. Depending on the age and condition of your system sometimes it makes sense to replace the entire unit.


How do you calculate the heat of compression for an air compressor?

enthalpy of air leaving the compressor minus enthalpy of air entering the compressor


Can we run our heat pump to heat the house even though the compressor is not working?

No. The compressor is needed to run in reverse in order to pull warm air from the outside to heat the home.


What heat energy in the suction vapor entering the compressor is?

The heat energy in the suction vapor entering the compressor is primarily due to the vapor being at an elevated temperature from the surrounding air or environment. This heat energy is required to raise the temperature of the refrigerant to the point where it can be compressed effectively by the compressor.