In general no, it might do some damage to both the equipment and the power supply. In certain specific cases it might be all right if you are able to measure the current to make sure it is 500 mA or less, and you can also ensure that the appliance can withstand 15 v.
No. If you need 15vdc, the 12vdc supply will not provide it, even if it is underloaded.
A: Disregarding the fact of different voltages there is the power to be concerned 9v x 1A = 9W, 15V X .8 = 12W. THE DEVICE WILL BE UNDER POWER.
Just connect the circuit. It will only draw the amps it needs to operate. It is just like connecting a 100 watt light bulb that draws way less than 1 amp, to a 20 amp household circuit.
yes uou can use but you have to use external battery charger 13.5 v-15 v, 5 amp charger .
2
The supply won't have to work as hard. It is perfectly acceptable, for example, to use a 1A, 12v supply to supply a 12v, .5A load. The current rating indicates the ability of the supply to dissipate heat caused by the current flowing. If the load current is above the power supply current rating, the power supply will overheat.
input voltage is strictly according to applications. If use 12V dc adapter power 5V dc device, the 5v dc device would be damaged.
i am not sure, BUT according to the answer in this post:Can_you_use_a_9V_600mA_adapter_on_a_9V_400ma_scanneryou need an adaptor of 9v and AT LEAST 500mA (assuming that the appliance draws 500mA)
Probably not. The other way around would be fine: a device that only needs 750mA will work fine on a 2A power supply, but one that needs 2A will NOT work on only 750mA, which is less than half the current required.
Yes.
Almost certainly.
Yes you can. It will just take a little longer to complete the charge cycle.
Yes - it will just take a little longer to charge the device.
You can use any 9v adapter as long as the output amperage is rated higher than the amperage rating of your appliance so yes a 600ma adapter can be used to power a 500ma or 400ma appliance
No. Your portable radio needs 800mA to operate. Your adapter can only produce 400mA. If you make the connection the adapter will rapidly heat up and probably burn out.
can a 12v lawn mower sealed battery be charged with 12v battery charger use on cars
if you have 12v dc then you can use a 4 ohm resistor
A: Disregarding the fact of different voltages there is the power to be concerned 9v x 1A = 9W, 15V X .8 = 12W. THE DEVICE WILL BE UNDER POWER.