No, the excessive voltage will destroy the equipment, unless the fuse trips (hopefully) ...
No, the excessive voltage will destroy the equipment, unless the fuse trips (hopefully) ...
NO
No. You should use the adapter specified for the DVD player. Using the wrong adapter can damage the DVD player and/or the adapter and/or cause a fire.
There are many electronics today that run on 12 volt DC power. The good news for anyone who is traveling is that you can use a 12 volt AC adapter 12 VAC 2A.
No, the battery is DC not AC.
No. You need 12 volt AC to run a 12 volt AC motor, not 12 volt DC.
No you shouldn't use a 14 volt 5 amp adapter on a 12 volt 5 amp device unless you know for sure that the 12 volt device has an internal voltage regulator that will lower the voltage to the correct voltage range the device was designed to use. As long as you always take care to check the output voltage with a voltmeter first, to be sure that the voltage from the adapter is regulated, meaning that it does not rise when a lower current in amps is drawn from it, you may be able to use an adapter that gives the right voltage at a higher amp output rating than the device actually takes. (For example, it may be possible to use a 12 volt 7 amp adapter for a 12 volt 5 amp device.)
You'll fry it
No, 12 volt AC is a different from 12 volt DC. Have a second look at the 12 AC volt adapter's output label. Most adapters contain a bridge rectifier in them that makes a conversion within the adapter. An example of this is in phone chargers.
To use an adapter of this sort, its rated voltage must match the rated voltage of the appliance, and its rated current must exceed that of the appliance. So, in your example, the rated voltage is too high to be used with your appliance.
No, it is not recommended to substitute a 12 volt 0.5 amp AC adapter with a 7.5 volt 1 amp adapter. The voltage and amperage ratings need to match the requirements of the device you are powering. Using a lower voltage adapter may not provide enough power, and using a higher voltage adapter can potentially damage the device.
No, auto batteries are DC not AC.
The output of a 12 volt transformer is an alternating current (AC). Your adapter is a 12 volt transformer but it has a built in half wave or, more expensive ones, a full wave bridge rectifier. What this rectifier does is change AC to DC. Bridge rectifiers are cheap to purchase. Connect it to the output of the 12 volt transformer and you will get a DC voltage. Great little project.