answersLogoWhite

0

To change the water pump on a 1995 Toyota T100 SR5 with a 3.4L engine, first disconnect the battery and drain the coolant. Remove the serpentine belt, then take off the timing cover to access the water pump. Remove the bolts securing the pump, clean the mounting surface, and install the new pump with a new gasket. Reassemble everything in reverse order, refill the coolant, and check for leaks.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

How do you change a wheel stud on a 1995 1500?

HOW DO YOU CHANGE FRONT WHEEL STUDS ON A 1995 CHEVY LUMINA AUTOMOBILE?


How do you change oil pan gasket 1995 Chevy S-10 truck?

Need to know if it is the 4.3 or the 2.2 engine and if it is 2 wheel drive or 4 wheel drive.


How do you change the thermostat on a 1995 Suburban?

take the water outlet off the top of the engine and the thermostat should be right there


Where is the water pump located on a 1995 Chevy Lumina 3.4?

if this is front wheel drive it will be on the passanger side bottom of engine good luck replacing that it it is rear wheel drive its in the front bottom a little eaiser


How do you change the wheel bearings on a 1995 Geo Prizm?

Front or Rear? Both


How long to change a water pump on a 1995 Pontiac firebird?

Depends on which engine you have, but on either engine it should not take more than 4 hours for someone familar with the proceedure.


How do you fix a leaking rear brake on a 1995 Chevy Suburban?

change out your wheel cylinders..


What is mpg of a Ford duetto lwb motorhome 1995 model?

Is it possibl to change a diesal engine in a ford duetto 1995, for a turbo engine.


How do you change the alternator belt on a 1995 Dodge Caravan?

what is the engine size?


How do I change the engine in a 1995 VW Golf?

$2000 and German mechanic


How do you change the fog lamp in a 1995 Lexus sc300?

You have to remove the wheel well lining to have access.


How do you change a starter in a 1995 Aurora?

on the 1995 aurora to change out the starter the top end has to be pulled the starter is internal it is located on the drivers side of the engine