tack off mot er mounts on front of engine roll ahead so mot er gos up, block wheel. easy to get at.
the plugs on the back are very difficult. How is this done.
just remove the ignition coil packs located on top backside of Eng use a 7/32 socket and small ratchet now with that out your way you can reach back there with know problem and remove them with your standard spark plug socket, ratchet,extension,and swivel. Just did my 2001 Montana with No problem .peace of cake
you have got to take the Pentium off and then you can change the back spark plugs when you put the Pentium back on you need to tourqe the bolts to 16 inch pounds.
save lots of time. just remove the ignition coil packs located on top backside of Eng use a 7/32 socket and small ratchet now with that out your way you can reach back there with know problem and remove them with your standard spark plug socket, ratchet, extension, and swivel. Just did my 2001 Montana with No problem .peace of cake
remove intake manifoled to access back 3 plugs. time consuming but can be done
if coils are taken off,then you can access the back plugs ok! coils are on a plate with 3 bolts holding it on to engine. this is the best way to get at back plugs on v6.
remove the intake manifold then they're in the back. I'm sure u see the front 3. peace
easy.........take the old spark plugs out and put the new spark plugs back
I do not know but try googling it. That might help you in the future.
The spark plugs are actually located under the manifold on the top of the engine 3 in front and 3 in back....
6 and 1/2 inches, round speakers on a 2000. Probably same on 2001.
you don't. you remove the air intake assembly from the airbox back. Then you remove the intake manifold, leaving the throttlebody attached to it. Then you should be able to pullit outof your way far enough to get to the spark plugs.