answersLogoWhite

0

Coolant temperature sensor is located on the front of the engine. The coolant temperature sensor is a few inches above the thermostat housing.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Where is the coolant temperature sensor located on a 2000 Ford Focus zetec?

cooling fan not work on ford focus zetec


Where is the coolant temperature switch on a Ford Focus zetec engine?

There is no such thing as a: temperature switch, on your Ford focus, the coolant temperature sensor is located on the front of the engine.


What is the coolant capacity for a 1.3 Ford Fiesta?

I just looked in the manual for my 1999 1.25 zetec Fiesta and it says the capacity is 6 litres


Location of map sensor on 2003 fiesta 1.4 tdci?

hai my car is ford fiesta zetec 2003 5door ,in my cay o2 sensor have fault .can you tell me how many o2 sensor are there and were is location


Where is the Thermostat on a Ford Fiesta zetec 1.4?

where is the thermostat on a 1.4 1997 ford fiesta zetec engine


Ford Fiesta 1.25 zetec drive belt diagram?

How to route Ford Fiesta 1998 Zetec alternator belt


How do you bleed water system on 00 zetec-s fiesta 1.6?

To bleed the water system on a 2000 Zetec-S Fiesta 1.6, start by ensuring the engine is cool. Remove the expansion tank cap and top up the coolant if necessary. Run the engine until it reaches operating temperature with the heater set to maximum. Keep an eye on the coolant level, adding more as air bubbles are expelled, and ensure there are no leaks before replacing the cap.


What causes temperature gauge to go up and cold air comes out of Ford Fiesta zetec but when you take off water cap off temporary solves the problem?

Air is in coolant system. Bleed system to fix.


What is the hp for a 1.25 fiesta zetec?

the mk6 fiesta 1.25 has 75bhp.


What is the latest type of Fiesta Zetec?

The2013 Ford Fiesta Zetec 1,0 litere eco-boost is the latest version of the Fiesta Zetec in Britain. As of January, 2013 17,000 units have already been sold, making it quite popular.


How do you bleed cooling system on a 1.6 zetec s fiesta?

To bleed the cooling system on a 1.6 Zetec S Fiesta, first ensure the engine is cool and the radiator cap is off. Start the engine and let it run until it reaches operating temperature, allowing the thermostat to open. Keep an eye on the coolant level and add coolant as necessary while squeezing the upper radiator hose to help release any trapped air. Once the air bubbles have stopped and the coolant level stabilizes, replace the radiator cap and check for leaks.


Where is the intake air temperature sensor on a fiesta si?

The intake air temperature sensor on a Fiesta Si is typically located near the air intake or air filter housing. It's usually a small sensor with a two-wire connector that measures the temperature of the incoming air to help the engine control unit adjust the air-fuel mixture for optimal performance.