Want this question answered?
Formula for straight line depreciation is as follows: Depreciation = (Cost of asset - salvage value) / useful life of asset
Book cost ; sunk cost. A cost incurrence where the cash expenditure has already occurred, such as the cost of depreciation for a machine purchased several years ago.
Typically, you purchase these in packs. When I purchased a pack a few years ago, it cost me approximately $10.00. It should be around this price if not a few bucks higher.
Price of one gallon of gasoline cost 1.70 dollars in USA in 2000. Interestingly price of gasoline was 1.60 dollars in 1990 which means an increase of only 0.10 dollars in 10 years.
Because your right triangle is half of a rectangle, you would multiply one measurement by the other and then divide that by two. Then multiply that by 15 per square meter. Unfortunately, this will UNDER estimate your cost, as the triangular sail's hypotenuse is NOT a straight line. But it'll get you 'in the ballpark'.
If the opportunity cost is constant, the PPF is a straight line; when the opp. cost of a good rises when it is produced more, then concave.
Straight line method of depreciation is that under which any asset is depreciated in equal amount for every year till salvage value. Formula for straight line method: Depreciation = (Cost price - Salvage Value)/Number of years
178 mph on a straight away
The sum-of-the-year digits method is an accelerated depreciation method that allocates a larger portion of the asset's cost to the early years of its useful life, while the straight-line method evenly distributes the depreciation expense over the asset's useful life. As a result, the sum-of-the-year digits method results in higher depreciation expense in the earlier years and lower depreciation expense in the later years compared to the straight-line method.
The annual depreciation for the refrigerator using the straight-line method would be calculated as follows: (Cost of the refrigerator - Estimated salvage value) / Useful life = ($198,500 - $30,500) / 15 years = $168,000 / 15 years = $11,200 per year.
depreciation is classed as a fixed cost when using only the straight line method. reducing balancing method is classed as a variable cost.
Either just braces or both. I am 10 yrs old and i got my molds for my retainer yesterday and i will have that for 1 year and a half to 2 years. then i will get my braces for 2 years.
Isocost lines are straight because they represent all the possible combinations of inputs that can be purchased for a given total cost. Since the cost per unit of input is constant along a straight line, different combinations on the line will have the same total cost. This allows firms to find the most cost-effective way to produce a given level of output.
250-300
go to Advanced auto, ask for a piece of straight brakeline tubing, an end-flare tool, and a tubing bender. Total cost $20.00 max. I did this for my 1998 Ford F-150 2 years ago. It cost me $15.00 and 1 hour.
yes it does cut in a straight line but u have to sand the edges to get that sharp edge on the corner (cost £50) ♥
It costs around $30. However the price can vary.