on the right side of the engine
On a 1997 Isuzu Rodeo, the crankshaft position sensor is typically located near the bottom of the engine, close to the crankshaft pulley. It is mounted on the engine block or transmission bell housing, making it accessible from underneath the vehicle. To reach it, you may need to lift the vehicle for better access. Always consult a repair manual for specific details on your model.
On a 1997 Isuzu Rodeo with a 2.6L SOHC engine, the crankshaft position sensor is located on the engine block, near the flywheel or crankshaft pulley. It is typically mounted on the lower part of the engine, often on the driver's side. To access it, you may need to remove some components or covers for better visibility and clearance. Always consult a repair manual for specific details and diagrams.
its on the crossmember on the right rear...near the canister.
center drivers
it depends on the model of engine, my 97 rodeo with the 4ze1 motor has the map sensor for air intake but doesnt have an O2 sensor for the exhaust.
Where is my filter for my 97 ISUZU RODEO
How to remove the starter from a 1997 Isuzu Rodeo 4X4 automatic
How do I remove the front shock bottle pin of my Isuzu rodeo 2000
lol! On my 1997 Rodeo (v6, 3.2l) it is in the back -- the manifold must be removed to access it. lol! On my 1997 Rodeo (v6, 3.2l) it is in the back -- the manifold must be removed to access it.
the o2 sensors are located on the exhaust pipe one by trans and one by the muffler there is 2 of them
On a 1997 Isuzu Rodeo, the oil filter is located on the bottom front of the motor beneath the fan.
what type of transmission fluid used for a 97 Isuzu rodeo