0
Did hirohito say Americans had guns behind every blade of grasss?
Wiki User
∙ 11y ago
He would not attack America because he knew Americans had guns and knew how to use them... that there was "a gun behind every blade of grass."
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the value of a Elite Diamant bayonet?
If it's in good condition, matching blade & scabbard and has a frog with the bluing intact on the blade. Easily 300-400$
How does a hidden blade work?
Exactly the same as any other blade. by being stabbed into a victim until they die in a grisly fashion... The only difference is that it has been hidden somewhere so the victim doesn't know the other person has a blade, before its too late...
What is the Sebewaing Blade?
It is a newspaper for the town of Sebawaing, in Huron
How do you sharpen a samurai sword?
You get another blade and blunten it
Why are sabers of the American Revolution curved?
It allows the centre mass of the blade to be forward of the wrist as you strike. The momentum of the swing of the blade allows the curve to strike and focus its energy in the target.
What is the flat upper part of the tongue directly behind the tip?
BLADE
You have severe trapped wind behind your right shoulder blade?
Yes and my chest
Where is the water pump located on a 1993 f-150?
Behind the fan blade and pulley.
Why must you never stand directly behind the blade when cutting on the table saw?
Ther is always a danger the rotating blade will kick the material back. Kickback.
Where is the water pump located on a 1977 Plymouth volare?
right behind the fan blade on the engine.
Which way do you turn the bolt to remove the blade on a toro 36 inch walk behind mower?
The opposite direction that the blade rotates. In this case I would say counter clockwise but their should be a marking somewhere on the mower that shows blade rotation direction.
What is the wheel chamber pressure in turbine?
Resistance offered by turbine to the steam
How do you stick out your shoulder blades?
Put your left ( or right)hand behind your back so if you look behind your right (or left) shoulder, you'll see your hand. you dont see your shoulder blade but others will.
How do you change blade on Mk 470 tile Saw?
There is place on the shaft just behind the blade where a thin wrench can be fit in to hold the shaft. If you are like me, you lost the original shaft wrench. I had to manage to get the blade off by holding the blade and impacting the blade wrench repeatedly - the quick whack made it start to move little by little each time I whacked it until it began to loosen. Only then did I discover that there was a place just behind the blade where you could put a wrench on the shaft. It needs to be a relatively thin wrench. I don't know the exact size, but a 19 mm holds it well enough so that you can tighten or loosen the blade nut. If you have wrench about that size and thinner than a quarter inch, it should work.
Is the fastener for the lawn mower blade on a Briggs and Stratton reverse thread?
I don't know. I do know that the fastener that holds the blade on must be turned in the direction that the blade turns (when it's running) to take it off. Look to see which way the blade turns (you can tell by the cutting edges) and turn the fastener that direction to take it off. Think this through and you'll understand the applied physics behind this idea.
How do you change the blade on a Black and Decker navigator?
Place the saw on its side, with the blades cutting edge away from you. You will notice a black button on that side, toward the bottom of the saw, and just behind the blade. The button is usually black and is on the saw body, not on the blade. Push that button down. This releases the the blade mechanism that will allow you to push the blade away from you. The blade will push away to approximately a 90 degree angle, then just grasp the blade and it will loosen from the saw. To insert a new blade, just reverse the process. the new blade will slide over the oval retainer. Make sure it is seated properly, then just pull it toward you until it is seated. If the blade doesn't fit over the oval retainer you will have to rotate the retainer with a small wrench or pliers. Push the black button in and turn the oval retainer so it will line up with the slot on the blade.
What noun is used with a blade of?
The most common nouns that may be used with 'a blade of' may be a 'blade of grass' or a 'blade of steel'. There are other terms for a blade, for example the blade of a knife, the blade of a razor, or the blade of a lawnmower, etc.However, the noun 'blade' can also be used in an abstract context, for example:He wields the blade of power while I wield the blade of labor.
