0
The RG10 revolver, a model produced by RG Industries, typically does not feature an ejector rod. Instead, it uses a design that allows for manual extraction of cartridges. If your RG10 lacks an ejector rod, it is likely consistent with its standard design, as many RG revolvers were known for their simplicity and cost-effectiveness in manufacturing.
What else can I help you with?
How do you remove ejector rod from housing on HR 660 revolver?
Best left to a gunsmith
How do you remove ejector rod o a colt cobra?
IMHO, best left to a gunsmith to remove it.
Need complete ejector rod assembly for your Smith and Wesson Model 15 revolver?
Ejector will depend on barrel elngth (short barrelled revolvers have a short ejector rod as well) Check Numrich thru their website at gunpartscorp. You can also check Brownells, or any competent pistolsmith. When all else fails, check with S&W for recommendations.
What is the lug on a revolver?
A bit of metal on the underside of the barrel. The ejector rod snaps into the lug when the action is closed.
How do you unload a revolver?
If it's a modern revolver, you activate the cylinder release, open the cylinder, and push the ejector rod.
What is the lug on a revolver gun?
A bit of metal on the underside of the barrel. The ejector rod snaps into the lug when the action is closed.
What is the value of a colt 38 cal detective special with plastic grips and unschrouded ejector rod?
100-300 USD
How do I disasemble rohm rg10 22?
With a hammer, ;)
How do you remove the cylinder from SW 32?
While holding the cylinder use a pair of padded pliers to turn the ejector rod counter clockwise.
When was Rohm 22 rg10 produced?
1950s- 60s
How to find a Ejector rod for a Miroku Firearms Manufacturing Co 38 caliber?
gun shop, gun show, pawn shop, want ad
Price of liberty model rg10 pistol?
50 or so
