0
As i know,neutral is the return path of current & ground is for any leakage current
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is a ground fault?
difference in current between hot and neutral conductors
What is the difference between amphoteric and neutral compounds?
difference between amphoteric solutions and neutral solutions
What is the reading ground to neutral?
Ideally ground and neutral should be at the same potential, but as there is current in the neutral wire and no current (normally) in the ground wire there can be a difference. I have personally measured over 25 VAC on the neutral relative to ground in some systems.
GFCI circuitry often checks for a difference in current between the ground and neutral?
A GFCI monitors the current in the ungrounded (hot) conductor and the grounded (neutral) conductor. If there is more than 6mA of current difference between the two the GFCI will open the circuit.
What is the reason of the existence of a potential difference between the neutral point of the generator and the neutral point of the receiver?
Ground loop current, which is undesirable and every effort should be made to eliminate it.
Could a neutral wire be powered?
There should be zero voltage between neutral and ground.
When you test the outlet you get no current between power and neutral but you get it between power and ground?
There is an open circuit on neutral. You should have power between hot and neutral, as well as between hot and ground. Note well, however, that you should not pull any power between hot and ground, because ground is not intended to be a current carrying conductor - it is only there as a protective earth ground in the case of fault. You can not easily tell, at the outlet, if neutral and ground is reversed - you need to pull a load and then double check with a clamp on ammeter at the distribution panel.
Will an arc fault breaker work without a ground?
Yes a GFCI will work without a ground wire. A GFCI looks for a current differential between current in on the "hot" wire and current return on the neutral wire. Since current is the same throughout the circuit, no difference, no trip. If the load grounds out or shorts out, the current then takes the path of least resistance through the ground and not the neutral. This creates a difference between the "hot" and return neutral current and the device trips the circuit open.
Why we don't get shock if we touch neutral wire..we need two wires to close circuit pH and n when circuit closes current will flow around the circuit and one wire gets shocked other not why?
We don't get shocked when we touch neutral and ground because neutral is grounded back at the distribution panel, so the effective voltage between neutral and ground is very low. It won't be zero, because there is current flowing on neutral, causing a voltage difference between the load and the distribution panel, but it is low enough, assuming there is no malfunction, to not cause a shock.In the case of touching hot and neutral, or hot and ground, you will get shocked because there is line voltage between hot and neutral, and because neutral and ground are connected together, there is also line voltage between hot and ground.Note, however, that connecting a load between hot and ground is a violation of the code and the intent of the design, because ground is not rated to carry current except in short term fault conditions - you must always connect a load between hot and neutral, or between hot and hot, as the case may be.
What is meant by neutral grounding reactor?
Neutral-earthing reactors or Neutral grounding reactors are connected between the neutral of a power system and earth to limit the line-to-earth current to a desired value under system earth fault conditions.
What is the difference between the neutral and ground bar?
In any distribution panel there are individual bars for each termination. The ground buss is in direct contact with the metal enclosure. The neutral is isolated from the metal enclosure. The only place where the two come into contact with each other is where a bonding screw protrudes through the neutral bar and into the metal enclosure.
Can you use ohm-meter to measure a resistance between the neutral line N and the ground E?
If the meter is sensitive enough and there is a resistance between the neutral and ground then the meter should be able to detect it.
