unsymmetrical bending
Take a beam as an example. Moment is responsible for a beam to rotate about some axis. Whereas bending moment are a pair of moments which will not rotate the beam but it will deflect it.
When looking at someone from the rear. Levoscoliosis is when the curve of the spine is to the left, therefore the spine is bending to the right. Dextroscoliosis is when the curve of the spine is to the right, therefore the spine is bending to the left.
Refraction is the bending of light when it passes from one medium to another medium (like from air to glass). The basis for refraction is the speed of light is slightly different in the two mediums. Diffraction is the bending of light that occurs around a sharp edge (like light passing thru a slit). The basis for diffraction is the spreading out of the wave as it passes by the sharp edge.
mass moment of inertia is the property of the body to resist rotation about the given axis where as the area moment of inertia is the resistance to bending about the given axis
in strength of material, u studied shear force and bending moment diagram for static load ( load position is fixed) but influence line diagram is used to draw shear force diagram and bending moment diagram for moving load (load position varies with distance).. Recomended books, CS REDDY & BC PUNMIA.. or email me: parvez.civilengg@gmail.com
A three-phase symmetrical fault exists when all three line conductors are short-circuited, sometimes to earth (ground). An unsymmetrical fault occurs when only one or two of the three lines are involved.
Approximate Symmetry is approximately symmetrical. Regular Symmetry is Symmetrical for sure.
There is no difference because watch this ... 3 0
Asymmetric is the opposite of symmetric
It is equal on both sides so there is no difference between the sides !!
buckle means bending
The difference, major or not, is that an eclipse and a hyperbola are not related, at all. You might have meant to say "Ellipse". In that case, an ellipse is a closed line shape of which the left and right bouts are symmetrical and the top and bottom bouts are also symmetrical. A hyperbola can never close, and only its left and right parts are symmetrical.
"Simple DDA" does not require special skills for implementation.
symmetrical is where if you split it in half it would look the same on both sides but flipped over and asymmetrical is where each side is different thank you. you really helped me.
Buckling and bending are similar in that they both involve bending moments. In bending these moments are substantially independent of the resulting deflections, whereas in buckling the moments and deflections are mutually inter-dependent - so moments, deflections and stresses are not proportional to loads.Osman E.
Assumptions The beam is symmetrical about Y-Y The traverse plane sections remain plane and normal to the longitudinal fibres after bending (Beroulli's assumption) The fixed relationship between stress and strain (Young's Modulus)for the beam material is the same for tension and compression ( σ= E.e )
Take a beam as an example. Moment is responsible for a beam to rotate about some axis. Whereas bending moment are a pair of moments which will not rotate the beam but it will deflect it.