To replace spark plugs, you can use a socket wrench, but a socket made for removing and replacing spark plugs is needed. This socket is relatively inexpensive and can be found at most auto parts stores.
== ==
remove the pretty plastic on the top of the motor once remove you will have direct access to the front 3 spark plugs, to remove the rear spark plugs remove the intake manifold and then you will be able to access the back bank of spark plugs. then reassemble everything. tools needed ratchet and sockets and large extension
You will need the correct replacement spark plugs, a spark plug socket, and a screw driver. The new cars have the spark plugs concealed and you might have to open the cover over the engine to access it, which may require addition tools
How do I change spark plugs in 2009 Toyota Corolla? whaT TOOLS I NEED
You will need a general screwdriver, a spark plug socket, a socket wrench and and extender, a wire brush and a silicone dielectric compound. You should find more of these tools at SEARS or your favorite car parts dealer. You will need a spark plug wrench with an extension to replace the spark plugs in a 1998 Nissan Sentra. You can find an instructional video at www.youtube.com.
no you do not..
A half hour or so, assuming you have the right tools and know what you're doing.
Make sure you have the proper tools: 6"-8" Extension Nut driver/screwdriver (to remove coil packs) Spark plug socket with retainer (rubber washer) NGK spark plugs (bosch platnium plugs not recommended) Do them one at a time to ensure the plugs are replaced accordingly Spark plug gapper (ensure the plugs are gapped properly .044) DENCO come pre gapped; do not scrap needle point plugs (ruins electrode)
I had the garage do it, because reaching for one of the 6 plugs, you need to lift the passenger side front wheel of the ground and take the tire of to reach that one spark plug. Well, if you can, you should have no problem if you have the parts and tools...
no special tools required except a plug wrench most socket sets have plug sized sockets in them
If your Diamante is the Dohc 6 cyl. motor in it then you have to remove the entire intake manifold to replace the back 3 plugs I did it in about 4 hours with not many tools and I am a female. So it can be done.
with tools