0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the code for stairs treads to risers?
I need to know what the codes are on stairs? Treads@risers an hand rails ?for what degree of slope
When do you need a hand rail on both sides of a stair way in a commercial building?
Yes
How do you make a railway in minecraft?
You would need rails, detector rails, power rails, and minecarts.
Can skateboard trucks work on a longboard?
yeah, you'll need risers
Why would one need to install a stair lift?
One will need a pulley to install a stair lift as well as many other tools. A screwdriver, hammer, and perhaps even a stair lift kit would also be helpful in installing a stair lift.
What does the maglev need to work?
Magnetic Rails
Is it essential to use a baby stair gate?
No it is not essential to use a baby stair gate. If the baby is located at a home without stairs, there would be absolutely no need for one. On the other hand, if the location has any stairs, or even rooms that a parent does not want the baby near, a gate is imperative.
How many steps require handrail?
According to the building code, handrails are required on both sides of a stair, except for in individual dwelling units, stairways less than 44" wide and stairs having less than four risers. This means you need a handrail on at least one side of any stair more than just a single riser. (This is in addition to the requirement for guardrails if there is a dropoff to the side of the stair.) In a single-family home, DIY setting, you may be able to get away with less, but it would probably be unsafe. I think you will be fine if it is two foot or less that's the code for G.a
What does the maglev train need to work?
Magnetic Rails
Where can I find instructions for building stair ramps?
Ramp Solutions offers severel ways to build stair ramps and a place to get the materials. You could learn everything you need to know about stair ramps from one website.
What is the standard stair riser height?
They are the height it needs to be in order to make the desired number of treads connect the low and high points. That being said, Stair risers should be no more than 8" and treads should be no less than 11". Once your risers start being taller than your tread is long, you are building a ladder, not a stair. If you start at 8" for a riser and 11" as a tread, By shrinking the riser and adjusting the treads to fit you can get the steps to work out so that one consistent riser height can be achieved. One that will be in the 6-8" range. If you use risers that are less than 6", you should lengthen the treads. Example problem-- Lower floor is 6 feet lower than the higher floor. Keep in mind you always have 1 more riser than tread. 6'-0"= 72" You can make 18 each 4" risers (72"H /4"R=18 risers) and have a run of 34 feet using 24" treads. or you can make 12 each 6" risers and have a run of 11 feet using 12" treads. or you can make 9 each 8" risers and have a run of 7'-4" or 88" using 11" treads. You will always have at least one "given"-the height you need to traverse. From there it is just division and multiplication based on the 8" maximum riser and the 11" minimum tread.
Installation of X-Cargo Sport 20 Car Top Carrier I only have side rails do I need cross rails If so does it come with them?
Yes, you do need cross bars
