answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Do you need wire mesh on concrete pad?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can a concrete pad be considered a footprint?

That depends on whether you have concrete pad shaped feet.


How do you make a box trap?

firstly get some steel or wood and weld or nail them together to form a box then cover the box in mesh (leave on side open for the sliding door) hare a sliding door and attach it to the open end of the box tie some string or wire to it and tread the wire through the mesh close to the back. on the bottom attach a pad of some sort that when stepped on it goes down drill a hole in the pad and thread the wire through then tie a knot in the wire or attach a pin so that the sliding door stays up when the eg. rat walks in and steps on the pad the pad goes down and the pin or knot slides through the hole and the sliding door falls


Measuring square feet into yards of concrete?

1 cubic yard of concrete fills 27/depth in feet square feet.The number of cubic yards you need is(length of the pad in feet) x (width of the pad in feet) x (depth of the pad in inches)/324


How much does 36' x 12' of concrete cost in California?

That depends on how deep (thick) you need it to be. You'll need 1 yard of concrete for every 3/4 inch of thickness of the pad.


What is a launch pad made out of?

concrete


Is pad a noun?

Yes, pad is a noun. More specifically, it is a singular, common, concrete noun.


What should you use to anchor the medium shelter on a concrete pad?

anchor bolts made for concrete


How many yards of concrete for a 52ft by 48ft pad?

A 52' x 48' by 4" pad requires 30.8 cubic yards. If you go up to 6" thick you would need 46.2 cubic yards.


Where does the worn front brake pad detection wire connect on the front brake assembly for a 2001 vw jetta this came unattached upon changing the front brake pads and rotors?

If you are reffering to the end that connects to the brake system(pad, rotor, caliper) then it is almost always contected to the pad. Some are permanently molded into a pad, thus you would need to buy a new pad and contect the lead wire to that pad, or there is usually a place on the pad itself (including the steel backing plate that hold the pad material) where the wear sensor clips into. -Brake Engineer


How do you reset the brake pad warning light on a vauxhall vectra?

Hi you can't reset the brake pad warning light, you need to refit old pad wear indicator wire into slot on bottom of inner pad, and feed wire through, re connect it and should be good, or you can pick up new set of wire quite cheap, so just replace and do the same as above, thanks claire the light came up on mine i cut the wire of on the sensor end hooked the wires up together problem solved


How large of a concrete pad could you make with 5 cubic yards?

Depends on how thick the concrete pad is. At 4 inches thick and allowing for a little waste and imprecise measurements, about 350 square feet. You can check out more options with the concrete calculator below.


Why does a concrete floor feel colder to you than a carpeted floor at the same temperature?

The carpet and pad are insulating you from the concrete floor.