single
take the tire off the left front and open the front fender wall the battery is behind there
Go to this web site called installdr.com it will give you the color codes you are looking for.
There are 2 little buttons on the radio display one for the hour and one for the minute that you have to press with a pin or something sharp of some sort to adjust the time.
with satnav/display it's a Double DIN.
sorry, no it will not. they changed the radios in 2000. notice the face on the 2002 has round corners but the 98 has square corners. now the good news any radio out of a Dakota/ram/stratus/breeze etc from 99 back about 5-6 years will fit. I just put a 96 stratus am/FM/cass/CD in my 97 Dakota & son did the same in his 99 ram
No. It is not able to fit in the radio slot. If you take the stock radio out, and try to slip the Double-Din radio in, it will not even fit. Even if you cut it, you still have to re-cut the holes for the mount. Because the Double-Din radio runs into the mounting holes.
din and a half
No. The Accents will only take a single DIN type radio.
first you have to pop the cover off that's around the radio and then remove the 2 screwes that holds the radio. second unplug the wire connector from the radio. you also need a stereo connector for your aftermarket CD player to connect to the existing wire connector. once you have installed the connector to your CD player you need a installation kit for a 2000 dodge stratus to put your CD player in and bolt it to the existing holes your radio came from. plug your connectors and antenna wire together and reinstall your 2 screwes and pop your cover back on and you are done.
The power door locks and the radio in a 2000 Dodge Stratus SE may stop working at the same time because of a blown fuse. Another issue may be faulty wiring causing a problem for one or both of the issues. Both of these problems can be fixed by taking the vehicle to an automotive garage or shop to be fixed by someone who has experience in these vehicles.
You have two options. A single din, and a double din, single usually comes with a pocket under, whereas double replaces your entire stock radio.
One of the easiest and quickest ways to do this, is to go to an audio store and buy a wire harness. It should plug right into the factory plug (providing that it is still intact) and then plug into your new radio. If not, it will have ready to go wires for the harness that came with your radio.