no it does not. It does have an electronic control module that will very often go bad in the heat. it is located on the drivers side fender.
Not with out major modifications. The AMC 360 in a Wagoneer and the Chrysler 360 are completely different vehicles.Not with out major modifications. The AMC 360 in a Wagoneer and the Chrysler 360 are completely different vehicles.
the 89 with the 360 has the pcv valve in line behind the carburator.
Yes you should be able to make this swap.
If you are refering to the belt tensioner. I have not seen one on a grand wagoneer with a 360.
if it has the 360 engine look on below and behind the distributor. you can follow the fuel line from the carb to it.
I have a 229 A in my Grand Wagonner fron -84 (with 360 engine)
With an AMC 360 V8, it is 5000 pounds
W/ 360 engine,my 1988 GWweighed 4480 lbs.
jeep grand wagoneer 1986 5.9l v8 amc 360
If it has a 360 motor the mechanical fuel pump is located below the distributor. there could be an after market electrical fuel pump located near the tank. these answers are based upon my 89 grand wagoneer with a 360. The fuel pump on an 88 Wagoneer is in the fuel tank itself.
Torque Flite 727 3 speed
T-Case is most likely an NP229