0
Only if it has failed.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
How do i fix a Coolant leak under the throttle body?
You will need to remove the throttle body and replace the throttle body gasket. The throttle body gasket can be purchased at most auto-parts stores.
How to replace the front right side turn signal assembly for a 1985 Lincoln Continental?
i need to replace a throttle sensor and put a throttle body rebuild kit in
Throttle body injectors not firing on 1990 impala?
Need to replace ingnetion module in the distributor.
How do you replace a knock sensor?
you will need to take off the intercooler as its just under the throttle body.
How do you repair a throttle body fuel leak on a 1997 cavalier 2.2?
Check the throttle body over carefully to find the leak. If a gasket is leaking then a new gasket set will stop the leak. If the body has a crack then you will need to replace the throttle body.
Do you need a mechanic to replace an egr valve on a 2004 Mitsubishi galant?
No you do not! th egr valve is located just under the throttle body. there are 2 10mm bolts holding it in, you just need to remove air intake to the throttle body! it is directly under it!
How hard is to replace a throttle position sensor and where is it located on a 96 Chrysler Sebring Convrtible?
It is attached to the throttle body opposite of where the throttle cable attaches. You need a torx screwdriver, I'm not exactly sure of the size. the sensor is spring loaded and you must fit the tab inside the notches in the throttle body and slightly rotate it to the correct position and then replace the screws. You might need to have a scantool to reset the sensor in the computer but I'm not fully sure of that.
What do you repair for a P0120 code?
To repair the P0120 code you need replace the Throttle Position Sensor/Switch. You will find it located on the throttle body of the intake manifold in the engine compartment of your vehicle.
Need diagram to replace mass airflow sensor in a grand prix gtp?
its the flat square one on top of the throttle body
Where is the IAC valve in the 2000 Honda Accord V6?
It's under the throttle body. To get to it, you'll need to remove the throttle body and flip it upside down. The IAC valve is mounted by two screws to the throttle body, and it has a gasket that you will need to replace if you remove the IAC valve, so make sure you have a new gasket on hand if you intend to take off the IAC valve.
Diagram on the engine of a 2001 Oldsmobile silhouette you need to replace the thermostat?
how do you get the throttle body off so I can reach the thermostat house to replace the thermostat? Does the exhaust shield also need to come off? I have removed one bolt and two nuts on the throttle housing, are there more ? I can't find them.
How do you replace the idle control valve in a 2003 dodge ram 5.7 liter hemi?
The 5.7L Hemi does not have an idle control valve. Idle speed is regulated by the computer by opening or closing the throttle plate itself. The motor is a non serviceable part of the throttle body. The entire throttle body would need replaced if malfunctioning.The 5.7L Hemi does not have an idle control valve. Idle speed is regulated by the computer by opening or closing the throttle plate itself. The motor is a non serviceable part of the throttle body. The entire throttle body would need replaced if malfunctioning.
