No it will not
How do I light pilot light on furnace
It could be different for every house.A side note: I'm taking that you mean where is the pilot light located in side your furnace? Depending on the of your furnace it's very possible your furnace does not have a pilot light, in fact it may have an ignition system with a flame management sensor. Try this; turn off the system with the main electrical cutoff switch, wait for about 2 minuets, turn on the switch raise the temperature of the thermostat high enough for the furnace to come on, this should work if it does not try one more time. If that fails call a HVAC & R technician.
At pilot light, pilot light flows around thermocouple.
No standing pilot, it is a spark ignition unit
Defective thermocouple or possibly a dirty or clogged pilot orifice.
My wall furnace has an overheat safety switch. It's up near the top on the side of the unit. If the exhaust vent gets too hot, it will trip the switch off. I use a small screwdriver to reset the switch by pushing the little red button. The switch when activated shuts the thermostat to off. By resetting it, the thermostat will now work.
If this is happening you need to get your furnace serviced by a qualified engineer.
There are 55,000 BTU in an intertherm furnace pilot light. It is a way of heating up a place.
The detailed directions are printed on front of EVERY gas regulator. - However, in general, turn regulator switch to OFF for 2 minutes, then to PILOT and depress for one minute, then light pilot or press clicker till it lights. Keep PILOT pressed for 2 more minutes then slowly release it. If it stays on then turn main switch to RUN or ON.
When pilot light goes out, gas flows out of the pilot light nozzle. If out has continued for a long time, a gas cloud can develop around the furnace. When you go to light the pilot light, you'll ignite this gas cloud and make a big fire ball. If your basement is drafty, you might never get a huge cloud of gas hovering around your furnace. When you notice that your pilot light is out, you should shut off the gas to the furnace and allow any stray gas to dissipate before you turn the gas back on and light the pilot light. alliedallcityinc.com
There are several reasons why a pilot light could be going on. One reason is there could be a light breeze that is extinguishing the flame.
i have a model 125u19 payne furnace i move the thermostat but nothing comes on in the furnace and the pilot light is lit