The stress concentration factor depends on geometry, not on properties. For example if stress concentration factor around a circular hole is 3.0, that is the same for aluminum, steel, etc.
Co efficient increasing/degreasing the contact circle is the correction factor in gear.
Fouling factor is essentially used in determining the efficiency of the heat exchangers. Fouling factor is obtained from service (product) on either side of tubes and material of tubes. It basically represents corrosion of heat exchangers tubes which affects efficiency of heat transfer.
it's 1.75 - 2.00
The disturbance factor in steam blowing is a parameter that says how effective is the steam blowing regarding the pipinginternal surface cleaning process. It is the ratio between density*speed^2 in blowing and normal operation conditions conditions. rudi
less then 1
mass and distance
Concentration factor, CF = 1/Dilution factor, DF if DF = 5 then CF = 1/5 CF = 0.2
well salt is a abiotic factor..
BMFi =Ciorganism / Cidiet Ciorganism = concentration of i in organism Cidiet = concentration of i in diet BMFi = biomagnification factor of chemical i
Concentration factor
Concentration of sugar in the water
The state of material depends on its temperatures and properties. Pressure also plays a factor in the state of material. Under a normal temperature and pressure the material takes it's natural form but if there is any alteration in properties it will take another form.
ADH
concentration- hypertonic or hypotonic
Normal concentration is the ratio between molar concentration and an equivalence factor.
Water
r factor..the higher the factor the better the insulation