Want this question answered?
Any head can be put on any shaft. All you have to do is put the bottom of the head in warm not boiling water, just warm tap water for a few minutes and it should slide rite on to your maverick shaft if it doesn't already.
yea i have 1 just like that
$40 to $60
Yes, you can use any head besides the STX duel head. If the head you use is too big for the shaft, put tape on the shaft until the head fits snug. If it is too big for the head, head the throat of the head with a blow dryer and slide the head on.
The shaft in lacrosse is the stick part. The butt is the rubber stopper on the end of the stick. The head is the plastic part which has the pocket. The shaft is the part of the stick where you hold it.
It shouldn't matter. Any head should fit on any shaft
the shaft itself is 60" long. With a head attached it is 6ft.
I would recommend that you do put a crank shaft head on a crank shaft. Putting any other type of head on a crank shaft could possibly break the head.
Wrap tape around the top of the shaft to however much more thicker you need. The best tape to use is electrical.
only if it is blacked out
no, just use muscle !
To get a very tight Lacrosse head onto a shaft, spray both sides with a lubricant. WD-40 is a good lubricant for this procedure. Liquid Wrench will also work.